Overview
The Advanced Accessory Concepts Trigger Accessory Control System, part 2001, is a universal controller that runs electronic accessories without wires run under the dash or through the firewall. Several Trigger control boxes and remotes can work together to control up to 24 accessories. Because the system is not sized for one vehicle, its fitment is universal.
The control box uses four solid state relay channels, two rated 30 amp and two rated 10 amp, for 12 to 24 volt systems. Its fuses sit under a waterproof cover, with 30 amp fuses on circuits 1 and 2 and 10 amp fuses on circuits 3 and 4. LEDs show when a relay is on and when a fuse has blown, so a fault is easy to spot.
The battery-powered RF remote is the main way to operate accessories from outside the cab. It has backlit buttons and a universal mount that fits round or flat surfaces, and it can be programmed for security or for use with additional remotes. On a UTV roll bar, the remote buttons are easier to reach than dash switches, with no straining against seat belts.
A Bluetooth app adds on/off and dimming control, and it can flash lights that run on LED or conventional bulbs. Manual on/off buttons on top of the case give direct control when no phone is nearby.
Key features
- Controls up to 24 accessories when several control boxes and remotes are combined
- Four solid state relay channels: two rated 30 amp and two rated 10 amp
- Operates 12 to 24 volt systems
- Built-in fuses under a waterproof cover, with LED indicators for relay status and blown fuses
- Battery-powered RF remote with backlit, programmable buttons
- Bluetooth app for on/off, dimming and flashing
- Waterproof case that withstands temperatures to 250 degrees
- Waterproof connectors on the control box and the harnesses
Choosing accessory controls
A controller like this one simplifies the wiring for lights and other electronics, but the wiring plan still matters. Each accessory draws current, and the fuses and relay channels must suit the load. Plan which accessories share a circuit, and keep switched and battery circuits separate so one fault does not affect the whole system.
Remote control is most useful when the buttons are easy to reach from the driver’s position and the mounting spot stays dry and secure. Harness routing should avoid hot exhaust areas, moving parts and sharp edges. Waterproof connectors help, but they only work when the wires are strain relieved and sealed correctly.
- Label each circuit at the control box
- Check fuse ratings against each accessory’s draw
- Keep the RF remote charged or check the battery regularly
Specifications
| Brand | Advanced Accessory Concepts |
|---|---|
| Part number | 2001 |
| UPC | 858208006702 |
| Relays | Two 30 amp, two 10 amp, all solid state |
| Voltage | 12 to 24 volt |
| Input | 12 volt, 3 wires: ground, switched positive, battery positive |
| Output | 12 volt, waterproof connectors |
| Fuses | 30 amp on circuits 1 and 2, 10 amp on circuits 3 and 4 |
| Case temperature rating | 250 degrees |
| Remote | Battery-powered RF, backlit, universal mount |
Vehicle fitment
This is a universal accessory controller. It is not vehicle-specific, and the remote’s universal mount accepts round or flat surfaces, which includes a UTV roll bar.
Installation notes
The 12 volt input has three wires: ground, switched positive and battery positive. Wire that input before connecting any accessory, and use the waterproof connectors supplied on the control box and harnesses for the outputs.
What’s included
The kit includes the control box, the battery-powered RF remote with its universal mount, the waterproof connectors and the built-in fuses. Accessories and lighting are sold separately.




















