Overview
The Icon Suspension 196275 is a 6 inch block kit for the Ford Excursion and the F-250 and F-350 Super Duty. The kit contains two 6 inch fabricated blocks that sit between the axle and the spring to raise the vehicle.
The blocks are flat like the factory block and have a built-in bump-stop tang. The kit is for the 2000–2005 Ford Excursion and the 1999–2007 Ford F-250 and F-350 Super Duty in the trims named below.
Key features
- Two 6 inch fabricated blocks per kit
- Flat design like the factory block
- Built-in bump-stop tang
Ride height and axle position
Blocks raise the axle, not the frame, so the change shows up at the rear springs and the driveline. Raising the axle alters pinion angle, which can cause vibration if it moves too far from the transmission output angle. The block also changes spring geometry, so the ride may feel firmer or the axle may sit at a different angle under load.
The bump-stop tang helps limit travel, but it does not replace a check of shock length. Shocks and brake lines may need to be rechecked after the change in ride height. Because blocks are often used with heavier loads, periodic inspection of the spring seat and mounting bolts helps catch problems before they grow.
- Check pinion angle after the blocks are installed
- Inspect the bump-stop tang for cracks
- Recheck brake line slack at the axle
- Review shock length against the new ride height
Specifications
| Brand | Icon Suspension |
|---|---|
| Part number | 196275 |
| UPC | 70000395107 |
| Block height | 6 inch |
| Quantity | 2 blocks |
| Construction | Fabricated, flat |
| Bump stop | Built-in tang |
Vehicle fitment
The manufacturer fitment list covers the 2000–2005 Ford Excursion (Eddie Bauer, Limited, XLS, XLT), the 1999–2007 Ford F-250 Super Duty and the 1999–2007 Ford F-350 Super Duty (Harley-Davidson Edition, King Ranch, Lariat, XL, XLT).
Excursion years outside 2000–2005 are not covered, and Super Duty years outside 1999–2007 are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The blocks change the axle position, so have the alignment and driveline angles checked after installation. Support the vehicle on jack stands before removing any axle or spring fasteners.
What’s included
Two 6 inch fabricated blocks with built-in bump-stop tangs.
Not included: Confirm whether U-bolts and other mounting hardware come with the kit before starting the install.




