Overview
The Warn 63004 is a black rock slider built from 3/16 inch thick steel plate with a black powder coat finish. It is a reinforced plate that bolts to the Jeep body at its weakest spot.
Mounting hardware is included, and installation requires some drilling, so this is not a no-modification fit.
Key features
- 3/16 inch thick reinforced steel plate
- Black powder coat finish
- Formed plate guard with standoff design
- Mounting hardware included
- Drilling required during installation
Drilling and layout
A plate guard that bolts to the body changes the body’s mounting points, so layout is the step that matters most. Hold the plate in position, mark the holes, and check that the guard clears the tire, the step and any wiring before drilling. Measuring twice keeps the finished guard level and evenly spaced.
Drilled holes cannot be undone, so take time to confirm every mark. Sheet metal can rust around new holes, so clean the edges and apply a touch of paint or a rust inhibitor after drilling. Re-tighten the hardware after the first few trips, since body flex can loosen fasteners.
- Mark and check hole positions before drilling
- Use a sharp bit and clear the metal chips
- Seal bare drilled edges with paint
- Check hardware tightness after first outings
Specifications
| Brand | Warn |
|---|---|
| Part number | 63004 |
| UPC | 12748630043 |
| Material | Steel plate |
| Plate thickness | 3/16 in |
| Finish | Black powder coat |
| Type | Formed plate guard with standoff |
| Installation type | Cutting or drilling required |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct-fit guard for Jeep vehicles. Confirm fit for your vehicle’s year, model and trim before ordering.
Check the Jeep models and years this guard covers before installing.
Installation notes
Some drilling is required, so measure and confirm placement before cutting into the body. Because the plate bolts to the body, drilled holes cannot be undone, so verify the layout first.
What’s included
Mounting hardware is supplied with the guard. Count the hardware against your mounting points before drilling.












