Overview
The Warn 63253 is a Rock Crawler tire carrier that attaches to the WARN Tire Carrier bumper, which is sold separately, and is built to hold heavier spare tires. It carries spare tires up to 36 inch, with the maximum also shown as 37 inch.
The carrier pivots on a 1.5 inch solid steel shaft that is welded in place rather than bolted. Structural T-joint welds replace corner welds, which helps the bumper hold up over the long run. A polyurethane pad reduces rattling, and the carrier fits the 1976–1983 Jeep CJ5 and the 1976–1986 Jeep CJ7.
Key features
- 1.5 inch solid steel pivot shaft
- Shaft welded in place, not bolted
- Structural T-joint welds for the mount
- Polyurethane pad to reduce rattling
- Black powder coat finish
- Frame-reinforcing brackets included
- Bumper mount design for the WARN Tire Carrier bumper
Mounting a heavy spare
A carrier that swings a heavy spare puts sustained load on its pivot shaft and welds. Before each trip, look at the weld joints for cracks and check the pivot for play. A polyurethane pad between parts helps cut rattling, but worn pads should be replaced so metal does not contact metal.
Frame-reinforcing brackets spread the load into the frame, so make sure they are fastened tightly and not bent. When you add a spare, keep it centered and secured so the bumper is not pulled off balance. Bumpers on older CJ models can rust near mounting points, so check those areas each season and treat surface corrosion early. Off-road trips with a loaded spare are where any looseness shows up first.
Specifications
| Brand | Warn |
|---|---|
| Part number | 63253 |
| UPC | 1274863253 |
| Finish | Black powder coat |
| Pivot shaft | 1.5 inch solid steel |
| Maximum tire size | 37 inch (feature list); 36 inch (description) |
| Mount | Bumper mount |
| Fitment type | Direct fit |
| Compatible rear bumper | Part number 62947 |
Vehicle fitment
It fits the 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade) and the 1976–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade). Wrangler YJ, TJ and JK models fall outside this fit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The carrier is designed for the WARN bumper and includes frame-reinforcing brackets, so both the bumper and frame share the load. Warn’s copy does not spell out mounting steps, so follow the instructions packed with the kit. A heavy spare adds weight to the bumper, so confirm the bumper is fitted correctly before mounting a tire.
What’s included
Tire carrier with a 1.5 inch pivot shaft, polyurethane pad and frame-reinforcing brackets.
Not included: The WARN Tire Carrier bumper, which is sold separately, rear bumper part number 62947, and the spare tire.














