Overview
The Fab Fours Vengeance Rear Sensor Bumper in black powder coat, part number FF17-E4351-1, fits the 2017–2018 Ford F-150 Raptor. It is a rear replacement bumper built from 11 gauge U.S. steel.
Pre-cut openings accept the factory sensors, and two side openings take one Rigid Industries 6-inch SR Series light on each side. The lights are sold separately. The OEM receiver hitch and wiring location are retained. The bumper weighs 60 lb and is designed for strength without extra weight.
Key features
- Fits the 2017 to 2018 Ford Raptor
- 11 gauge U.S. steel construction
- Pre-cut openings for the factory sensors
- Two side openings for Rigid Industries 6-inch SR Series lights
- Fab Fours 2 stage black powder coat
- Retains the OEM receiver hitch and wiring location
Rear bumper weight and mounting
A rear bumper carries more than its own weight when the tailgate or a hitch load shifts. Check the receiver hitch and its bolts whenever the bumper comes off, because the hitch and the bumper share mounting points on many trucks. Inspect the factory sensor openings for clean edges so the sensors sit square when refitted.
Side lights add wiring that runs through the bumper and into the rear of the truck. Route the harness away from moving parts and trailer wiring, use a fused feed and check the ground point. Clean the powder-coated surfaces periodically to keep mounting areas free of mud and road salt.
- Inspect bumper mounts for cracks after hard landings
- Recheck hitch receiver bolts after the bumper is refitted
- Seal harness splices against water
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | FF17-E4351-1 |
| UPC | 5810114602 |
| Product type | Rear replacement sensor bumper |
| Series | Vengeance |
| Steel | 11 gauge U.S. steel |
| Finish | 2 stage black powder coat |
| Weight | 60 lb |
| Light openings | Two, for 6 in SR Series lights |
| Position | Rear |
| Fit type | Direct fit |
| Origin | Made in the USA |
Vehicle fitment
Fab Fours lists part FF17-E4351-1 for the 2017–2018 Ford F-150 Raptor.
The 2009–2014 Raptor and standard F-150 trucks are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Lights are wired separately because they are not included. The pre-cut sensor openings are matched to the factory sensors.
What’s included
One Vengeance rear sensor bumper.
Not included: Rigid Industries lights.









