Overview
The Fab Fours Aero Series Rear Bumper in black powder coat, part number FF17-E4371-1, fits the 2017–2018 Ford F-150 Raptor. It is a rear replacement bumper with a signature fluted castle design and pre-cut openings for the factory sensors.
The bumper is built from 11 gauge U.S. steel with 1.75-inch diameter tubing and measures 89 inches long, 12 inches high and 30 inches wide. It is lightweight for its size, at 60 lb.
Key features
- Fits the 2017 to 2018 Ford Raptor
- Signature fluted castle design
- 11 gauge U.S. steel with 1.75-inch diameter tubing
- Pre-cut openings for the factory sensors
- Fab Fours 2 stage black powder coat
- Retains the OEM receiver hitch and wiring location
Checking the rear end before fitting
A rear bumper does more than protect the tailgate. On a Raptor it carries the receiver hitch, the wiring for the trailer and parking sensors, and often a spare tire or carrier. Before you start, look over the factory mounting points, the hitch and the harness so you know what the new bumper must line up with. Clean the mounting surfaces and check that sensor wiring routes cleanly to each opening.
Replacement bumpers are usually fitted with the truck partly stripped, so keep fasteners sorted by location and have a helper for the heavier pieces. Inspect factory brackets for cracks or rust before reusing them. A steel bumper adds load to the rear mounts over time, especially after rough off-road use, so check welds and fastener torque after the first few drives.
- Inspect factory brackets for cracks or rust
- Keep sensor connectors clean and dry
- Confirm the hitch receiver sits square before towing
- Re-check fastener torque after the first drives
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | FF17-E4371-1 |
| UPC | 5810114848 |
| Product type | Rear replacement bumper |
| Series | Aero |
| Steel | 11 gauge U.S. steel |
| Tubing | 1.75 in diameter, .120 wall |
| Finish | 2 stage black powder coat |
| Weight | 60 lb |
| Length | 89 in |
| Height | 12 in |
| Width | 30 in |
| Position | Rear |
| Fit type | Direct fit |
| D-ring mounts | Not included |
| Tire carrier | None |
| Origin | Made in the USA |
Vehicle fitment
Fab Fours lists part FF17-E4371-1 for the 2017–2018 Ford F-150 Raptor.
The 2009–2014 Raptor and non-Raptor F-150 trucks are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pre-cut sensor openings are matched to the factory sensors, and the receiver hitch and wiring location stay as the factory placed them.
What’s included
One Aero rear bumper.
Not included: D-ring mounts.














