Overview
The Fab Fours Vengeance Rear Sensor Bumper in bare steel, part number FF17-E4351-B, fits the 2017–2018 Ford F-150 Raptor. It is a rear replacement bumper built from 11 gauge U.S. steel.
Pre-cut openings accept the factory sensors, and two side openings take one Rigid Industries 6-inch SR Series light on each side, sold separately. The bare finish means the owner applies the coating. The bumper weighs 60 lb.
Key features
- Fits the 2017 to 2018 Ford Raptor
- Bare steel finish
- 11 gauge U.S. steel construction
- Pre-cut openings for the factory sensors
- Two side openings for Rigid Industries 6-inch SR Series lights
- Retains the OEM receiver hitch and wiring location
Coating bare steel
Bare steel rusts once the mill finish is broken, so a rear bumper sold unpainted needs a coating before it sees road salt or wet trails. Clean the surface with a degreaser, scuff it lightly with a fine abrasive, and apply a metal primer followed by a topcoat that suits the truck’s use. Edges and welds deserve the most attention because they hold moisture.
Choose a coating based on how the truck is used. Textured coatings hide scratches better on trail use, while smoother paint is easier to touch up on a daily driver. Whichever finish is chosen, mask the sensor openings and light cutouts during coating so the edges stay clean for fitment.
- Test-fit the bumper before coating to confirm clearances
- Touch up chips quickly to stop rust spreading
- Coat the inside of hollow sections where water can collect
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | FF17-E4351-B |
| UPC | 5810114619 |
| Product type | Rear replacement sensor bumper |
| Series | Vengeance |
| Steel | 11 gauge U.S. steel |
| Finish | Bare steel |
| Weight | 60 lb |
| Light openings | Two, for 6 in SR Series lights |
| Position | Rear |
| Fit type | Direct fit |
| Origin | Made in the USA |
Vehicle fitment
Fab Fours lists part FF17-E4351-B for the 2017–2018 Ford F-150 Raptor.
The 2009–2014 Raptor and the standard F-150 models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Bare steel needs a protective coating before it goes on the truck. Lights for the side openings are wired separately.
What’s included
One Vengeance rear sensor bumper in bare steel.
Not included: Rigid Industries lights and any paint or coating.









