Overview
The Pro Comp Suspension U-bolt, part number 13-90269, is a round U-bolt used to clamp an axle or spring to a mounting plate. This one is listed in bulk and without hardware, so nuts and washers must be sourced separately.
The thread size is 0.5 inch by 20, and the dimensions are 2.55 by 6.5 inches. The clear zinc plated finish helps resist corrosion. Confirm the thread and bend dimensions against your axle and mounting plate before ordering.
Key features
- Round U-bolt
- 0.5 inch by 20 thread size
- Clear zinc plated finish
Choosing a U-bolt
A U-bolt clamps an axle or spring to a mounting plate, so its job is to hold a load steady under constant movement. Choosing one means matching the thread, the bend dimensions and the finish to the plate and axle it will clamp. The thread must engage the nuts fully, and the bend must sit flat across the plate without forcing the bolt into a shape that stresses the threads.
Tighten the nuts evenly, and check them again after the first few drives because clamped parts can settle. Clean the threads before fitting and use anti-seize only where the installation calls for it. Corrosion can weaken a U-bolt over time, especially where moisture collects, so inspect the bend and threads at regular service intervals and replace any bolt that shows rust through the finish.
- Check thread engagement on each nut
- Retighten after the first drives
- Inspect for rust at the bends
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 13-90269 |
| UPC | 614901130812 |
| Shape | Round |
| Thread | 0.5 inch by 20 |
| Dimensions | 0.5 in. -20 x 2.55 in. x 6.5 in. |
| Finish | Clear zinc plated |
Vehicle fitment
Confirm fit for your axle and mounting plate before installing it. Check the thread and bend dimensions against the mounting setup, since a U-bolt is sized to a specific application.
What’s included
This bolt comes without hardware. Nuts and washers need to be purchased separately.







