Overview
The Trail Gear 130020-1-KIT is a flat pitman arm for the 1984–1995 Toyota 4Runner and the 1979–1995 Toyota Pickup with power steering, with an FJ80 tapered hole.
The arm is a solid, one-piece forged design with a wide profile. It is built for use with crossover steering.
The FJ80 tapered hole is the detail that sets this arm apart, since it matches the tapered fitting used on the FJ80 steering box.
It fits the DLX and SR5 trims of the 4Runner, and the Base, Base Turbo, DLX, DLX Turbo, SR5 and SR5 Turbo trims of the Pickup. These are older solid-axle Toyota trucks, and the arm suits owners converting to crossover steering.
Key features
- Solid one piece, forged design
- FJ80 tapered hole
- Wide, solid forged build
- Ideal for use with crossover steering
- Flat arm design; check drop height against your steering setup before installing
- Power steering application
- Direct fit
- Lifetime warranty with no questions asked
Crossover steering basics
Crossover steering moves the drag link to a position across the front of the axle, so the pitman arm and drag link run at a different angle than a conventional setup. The arm’s geometry sets how the steering works, so its drop and length should match the rest of the linkage. Owners of solid-axle Toyota trucks often change the steering this way to free up clearance or to stiffen the front end.
Power steering boxes carry the load through the pitman arm, so check the box for leaks and the arm for looseness after the conversion. A new arm often goes with a drag link, tie rods and a steering stabilizer, which are commonly replaced together to keep the linkage matched.
- Check the steering box seal and fluid level after installation
- Inspect the pitman arm nut and taper for looseness
- Look at the drag link ends and tie rods for play
- Have a qualified technician check the steering alignment
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 130020-1-KIT |
| UPC | 70000621551 |
| Product type | Pitman arm |
| Design | Flat, one piece, forged |
| Tapered hole | FJ80 |
| Amount of drop | 2.5 inches in the specification line (description says flat, no drop) |
| Fit type | Direct fit |
| Steering type | Power steering |
| Warranty | Lifetime warranty |
Vehicle fitment
It fits two Toyota models across a long span of years, in the trims below.
- 1984–1995 Toyota 4Runner (DLX, SR5)
- 1979–1995 Toyota Pickup (Base, Base Turbo, DLX, DLX Turbo, SR5, SR5 Turbo)
Check fit against the year, model and trim of your truck before buying, especially for newer Toyota trucks such as the Tacoma.
Installation notes
The arm has an FJ80 tapered hole and is intended for crossover steering. Follow standard steering service practice, and have a qualified technician check the steering after installation.
What’s included
Check the package contents against your installation before starting.








