Overview
The Trail Gear 140006-1-KIT is a front knuckle rebuild kit for Toyota 8 Inch axles. It is a service kit that contains the standard replacement parts for the knuckle, including gaskets, felts, seals, washers, king pin shims and king pin trunion bearings.
It also includes inner axle seals and outer felt covers. Check fit against your vehicle’s year, model and trim before buying.
Key features
- Gaskets, felts, seals and washers
- King pin shims and king pin trunion bearings
- Inner axle seals and outer felt covers
- Front axle location
Rebuild planning
A knuckle rebuild touches the components that carry steering and axle loads, so the job goes best with a clear plan. Lay out the new seals, gaskets, shims and bearings before you start, and label the old shims by location so you can reuse them as reference. Keep fasteners sorted, and photograph the assembly at each stage so reassembly is straightforward.
Clean every surface before reassembly, and replace gaskets rather than reusing them. Watch for signs that the old parts were worn, such as grooves on the king pin, play at the trunion, or grease leaking past a seal. Those signs usually mean the rest of the assembly needs attention as well. Set the clearances carefully and test the steering through its full range before driving.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 140006-1-KIT |
| UPC | 70000621524 |
| Axle location | Front |
| Axle type | Toyota 8 Inch |
| Fit type | Direct Fit |
Vehicle fitment
The axle type is Toyota 8 Inch with a Direct Fit design. Check the year, model and trim of your vehicle before buying.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A knuckle rebuild means disassembling the front knuckle to reach the king pin and trunion components, so plan for shop time or an experienced technician.
What’s included
Gaskets, felts, seals, washers, king pin shims, king pin trunion bearings, inner axle seals and outer felt covers.
Not included: Check the package contents against your installation before starting, including whether the knuckle, hubs or axle shafts are needed.









