Overview
The Crown Automotive 8134036K is a Dana 35 rear axle bearing kit for the 1990–2001 Jeep Cherokee XJ, 1993–1998 Grand Cherokee ZJ and 1990–1995 Wrangler YJ, with the 1997–2004 Wrangler TJ and 2004 Wrangler LJ also listed.
Each kit contains an axle bearing and an oil seal. Two kits are needed per axle, one for each end of the axle shaft pair.
The part fits the rear position and is used with a Dana 35 rear axle.
Dana 35 rear axles appear under many Jeeps, so match the application to your vehicle. Two kits are needed per axle, with one serving each axle shaft. The kit is a bearing and oil seal pair, while some other Dana 35 kits add a retainer. Confirm whether your shaft is a C-clip or non C-clip design by checking the shaft you remove. The fitment covers Cherokee XJ, Grand Cherokee ZJ and several Wrangler generations.
Key features
- Axle bearing kit for the Dana 35 rear axle
- Contains an axle bearing and an oil seal
- Two kits needed per axle
- Rear position
- Direct fit
Dana 35 bearing service
The Dana 35 rear axle bearing supports the axle shaft at the housing end, and it carries the vehicle weight on that side. Wear usually appears as a growl or hum from the rear that changes with speed, or as play in the wheel when rocked. A leaking axle seal can contaminate the bearing with gear oil, which shortens its life quickly.
Replacement is best done with the axle shaft fully out, so the bearing bore and the shaft seat can be cleaned and checked. Use the correct press or driver to avoid damaging the race. Once the bearing is seated, refill the axle to the proper level with the correct gear oil and check the seal for leaks after a short test drive.
- Growl that changes with speed
- Play in the wheel when rocked
- Gear oil on the inside of the wheel
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 8134036K |
| UPC | 848399078176 |
| Part type | Axle bearing kit |
| Axle | Dana 35 rear |
| Kit contents | Axle bearing and oil seal |
| Kits needed per axle | 2 |
| Position | Rear |
Vehicle fitment
The 8134036K fits these Jeep models, with trims shown:
- 1990–2001 Jeep Cherokee (XJ) (Base, Briarwood, Classic, Country, Laredo, Limited, Pioneer, SE, Sport)
- 1993–1998 Jeep Grand Cherokee (ZJ) (5.9 Limited, Base, Laredo, Limited, Orvis, SE, TSi)
- 2004 Jeep Wrangler (LJ) (Unlimited)
- 1997–2004 Jeep Wrangler (TJ) (SE, Sahara, Sport, X)
- 1990–1995 Jeep Wrangler (YJ) (Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara)
Cherokee XJ fitment begins in 1990, so 1984–1989 XJ and Comanche models are not covered, and the 2007–2018 Wrangler JK is not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Plan for two kits to complete one axle. Confirm your axle design, including whether it uses C-clip shafts, before ordering.
What’s included
One axle bearing and one oil seal. Two kits are needed per axle.
Not included: a second kit for the other side, plus gaskets and gear oil.









