Overview
The Crown Automotive 83501451 is a non C-clip Dana 35 rear axle bearing and retainer kit for the 1984–1989 Jeep Cherokee XJ, 1986–1989 Comanche and 1987–1989 Wrangler YJ.
A bearing and retainer kit replaces the rear axle shaft bearing together with the retainer that holds it in place. This one is made for the non C-clip design of the Dana 35.
It is a direct-fit kit for the rear axle position in the vehicles covered here.
Dana 35 axles came in C-clip and non C-clip forms. In the non C-clip form a retainer plate holds the bearing on the shaft, so this kit includes a retainer rather than relying on a clip. It covers the earlier XJ, Comanche and YJ years, ending in 1989. The number of pieces and bearing dimensions should be checked against the parts removed from the axle.
Key features
- Dana 35 axle bearing and retainer kit
- Non C-clip design
- Rear position
- Direct fit
Bearing and retainer service
An axle bearing carries the axle shaft and takes side loads from the wheel, so its condition affects both wear and handling. In a non C-clip Dana 35, the retainer plate holds the bearing in place, and it should sit flat and undamaged with its fasteners secured. A cracked or bent retainer lets the bearing shift and can cause noise or a loose wheel feel.
During a bearing change, clean the axle tube and the seal bore, then check the axle shaft for wear where the bearing rides. Use a fresh seal and fasteners rather than reusing worn ones. Recheck the bearing for play after assembly, and make sure the brake parts clear the retainer before driving.
- Check the retainer plate for cracks
- Use fresh fasteners
- Confirm the brake components clear the retainer
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83501451 |
| UPC | 848399075212 |
| Part type | Axle bearing and retainer kit |
| Axle | Dana 35 |
| Axle design | Non C-clip |
| Position | Rear |
Vehicle fitment
The Crown Automotive list for 83501451 includes these vehicles:
- 1984–1989 Jeep Cherokee (XJ) (Base, Chief, Laredo, Limited, Pioneer, Sport)
- 1986–1989 Jeep Comanche (Base, Chief, Custom, Eliminator, Laredo, Pioneer, X, XLS)
- 1987–1989 Jeep Wrangler (YJ) (Base, Islander, Laredo, S, Sahara, Sport)
Years end in 1989, so later Cherokee XJ models and the Wrangler TJ are excluded, as are all Grand Cherokee models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the Dana 35 is the non C-clip type before ordering, since this kit is for that design only.
What’s included
One bearing and retainer kit, part number 83501451. Check the contents against the parts removed from your axle before installing.









