Overview
The Trail Gear 110007-1-KIT is a greasable front shackle reversal kit with a listed size of 5.0 in. Shackle reversal kits move the spring shackle from its stock position to the opposite end of the leaf spring. This kit uses threaded zerk fittings so the pivots can be greased, and it includes Polly bushings.
The kit is built for the front of the vehicle, with factory size 18mm bolts and crimp nuts, and its plates are zinc plated.
Key features
- Threaded zerk fittings for greasing the shackle pivots
- Factory size 18mm bolts with crimp nuts
- Zinc plated plates
- Polly bushings included
- Front offset design with a listed size of 5.0 in.
- Lengths are measured center of hole to center of hole, and stock shackles measure 3.5 in. between holes
Front shackle reversal basics
Shackle reversal moves the spring pivot from one end of the leaf spring to the other, which changes how the spring flexes and how far the axle can travel before the spring fully compresses. Because the spring geometry changes, the front driveline, steering linkage and brake lines should be checked for clearance after the job is done. Take time to confirm each one before the vehicle sees rough ground.
Greasable pivots help keep reversal hardware in working order, since the shackle moves with every bump. Keep the zerk fittings clean and inspect the bushings for splitting or flattening during routine service. Alignment is worth checking once the new geometry has settled, because a changed spring angle can shift caster and steering feel. Re-check the bolts after the first few trail runs.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 110007-1-KIT |
| UPC | 70000621525 |
| Product type | Greasable shackle kit (shackle reversal) |
| Listed size | 5.0 in. |
| Offset | Front offset |
| Stock shackle spacing | 3.5 in. between holes |
| Bolts | 18mm factory size with crimp nuts |
| Plates | Zinc plated |
| Bushings | Polly bushings |
| Grease fittings | Threaded zerk fittings |
Vehicle fitment
No vehicle or model years are named for this kit. It is a direct fit at the front, so confirm the application before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The listed 5.0 in. length is measured center to center, while stock shackles measure 3.5 in. between holes, so compare the new length with your spring before fitting. Changing shackle geometry alters suspension angles, so have the alignment checked after installation.
What’s included
Polly bushings are included. Plan for the zinc plated plates and factory size 18mm bolts with crimp nuts before fitting.









