Overview
The Trail Gear 303385-2-KIT is a bolt-on D-ring mount with a 3×3 inch mounting pattern, made for Trail Gear 3/4 inch D-rings. It is a mounting plate that holds the D-ring, and it is not tied to a specific vehicle.
The plate is 3/8 inch thick steel with a 1 inch thick D-ring mount and 1/2 inch laser cut hardware. It is offered in 3×3 and 3×3.5 inch patterns.
Key features
- Bolt-on mount with a 3×3 inch mounting pattern
- 3/8 inch thick steel plate
- 1 inch thick D-ring mount
- 1/2 inch laser cut hardware listed
- Built for Trail Gear 3/4 inch D-rings
Choosing a mounting point
A D-ring mount is only as strong as the point it is bolted to. Before buying, look at the frame, crossmember or bumper section you plan to use and confirm it is solid, free of rust, and able to take the pull of a recovery line. A bolt-on plate spreads the load across the fasteners, so the number and condition of the bolts matter as much as the plate itself. Thin or flexing sheet metal can tear out under a sudden jerk even when the hardware is good.
Because the 3×3 and 3×3.5 inch patterns are different, a mismatch will show up quickly at the fitting stage. Mark the hole spacing on the surface, check it against the plate, and avoid enlarging holes to force a fit. Once mounted, re-check the bolts after the first few trail runs, since vibration loosens fasteners over time.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 303385-2-KIT |
| UPC | 700007372571 |
| Mounting pattern | 3×3 inch |
| Plate material | 3/8 inch thick steel |
| D-ring mount thickness | 1 inch |
| Hardware | 1/2 inch laser cut |
| D-ring compatibility | Trail Gear 3/4 inch D-rings |
Vehicle fitment
It is not tied to a year, make or model, so the 3×3 inch pattern must match your mounting point. Confirm fit for your vehicle’s year, model and trim before ordering.
The mount is not tied to a year, make or model, so the 3×3 inch pattern must match your mounting point.
Installation notes
The mount is bolt-on, so it fits where the 3×3 inch pattern matches your mounting point. Measure the pattern on your vehicle before installing the kit, and confirm the D-ring is the 3/4 inch size this mount is built for.
What’s included
The 303385-2-KIT bolt-on D-ring mount with 1/2 inch laser cut hardware.
Not included: Check the package contents before installing; the mount is designed for Trail Gear 3/4 inch D-rings.












