Overview
The Trail Gear 303386-2-KIT is a bolt-on D-ring mount for Trail Gear ¾” D-rings. It is made from 3/8” thick steel with a 1” thick D-ring mount section and ½” laser cut hardware, and it is a universal application mount rather than one built for a specific vehicle.
The mount is offered in 3 x3 and 3 x3.5 mounting patterns. Match the pattern to the bolt layout on the surface where you plan to mount it before you install it, since the plate is sized for those two patterns.
Key features
- Bolt-on design for attaching a D-ring to a mounting surface
- Mounting plate of 3/8” thick steel
- 1” thick D-ring mount section
- ½” laser cut hardware
- Designed for Trail Gear ¾” D-rings
- Universal application with 3 x3 and 3 x3.5 mounting patterns
Preparing the mounting surface
The mounting surface carries the load from every pull, so it should be the first thing you inspect. Look for rust, cracks around existing holes and sections that flex when pushed by hand. Where the metal is thin, a reinforcing backing plate on the inside of the surface spreads the force and keeps the bolts from pulling through. Clean the contact faces so the plate sits flat, since debris can let the mount shift under a jerk.
Hardware quality matters as much as the plate. Use the fasteners that come with the mount and replace any that are bent, stretched or corroded. Lock washers or thread locker help resist loosening on rough trails. After the first few outings, check every bolt, look at the D-ring for wear, and inspect the welds or plate edges for hairline cracks.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 303386-2-KIT |
| UPC | 700007372581 |
| Material | Steel |
| Plate thickness | 3/8” |
| D-ring mount thickness | 1” |
| Plate size | 3”x3.5” |
| Hardware | ½” laser cut |
| D-ring compatibility | Trail Gear ¾” D-rings |
| Mounting patterns | 3 x3 and 3 x3.5 |
| Fitment | Universal application |
Vehicle fitment
Universal application means it is not built for one model, so the mounting surface and pattern on your vehicle decide fit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a bolt-on mount, so confirm the mounting surface and the 3 x3 or 3 x3.5 pattern before drilling or fastening. Make sure the mounting point can handle the loads your recovery gear will put on it.
What’s included
The kit includes ½” laser cut hardware. Check the package contents against your installation before starting.
Not included: The mount is designed for Trail Gear ¾” D-rings. Plan for a D-ring of that size.












