Overview
The TeraFlex 600494 is a passenger side front swaybar quick disconnect link for a 0-2 inch lift. It fits the Jeep Cherokee XJ and the Jeep Wrangler LJ and TJ.
The vehicle list covers 1997–2001 Jeep Cherokee XJ, 2004–2006 Jeep Wrangler LJ and 1997–2006 Jeep Wrangler TJ models. Only the passenger side link is described here, so confirm the side before ordering.
Key features
- Passenger side front position
- 0-2 inch lift range
- Quick disconnect link design
- Part number 600494 with UPC 843885017608
Swaybar link wear and replacement
The sway bar link carries side-to-side load between the front sway bar and the suspension. When a link wears, the sway bar can click or knock over bumps, and the bar may not control body lean as well as it did when new. Rubber bushings and ball joints at each end of the link are the usual wear points, so inspect the whole link rather than only one joint.
Quick disconnect links make it easier to unhook the sway bar during articulation or when working on the axle. Replacing one link without checking the other side can leave the bar uneven, so many owners inspect both front links at the same time. Check that the link ends and threads are clean before installing, and tighten fasteners to the specification in your service manual.
- Clunking over bumps or on turns
- Torn or cracked boot or bushing
- Play at the link ends
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 600494 |
| UPC | 843885017608 |
| Position | Front, passenger side |
| Lift range | 0-2 inch |
| Fit type | Direct Fit |
Vehicle fitment
The fitment covers 1997–2001 Jeep Cherokee (XJ) with Classic, Country, Limited, SE and Sport trims; 2004–2006 Jeep Wrangler (LJ) Unlimited and Unlimited Rubicon; and 1997–2006 Jeep Wrangler (TJ) with 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
No JK or JL Wrangler entries are on this list, and the XJ entries cover 1997–2001 only. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The package is one passenger side link. Plan the installation around that single part and check it against your setup before starting.









