Overview
The TeraFlex Steering Stabilizer Relocation Kit, part 1123140, moves the steering stabilizer up nearly 2.5 inch on 2007-2018 Jeep Wrangler JK vehicles. It helps reduce damage to the stabilizer shaft or body.
The kit uses a 6061 aluminum clamp and a forged 10.9 stud to reposition the stabilizer, which reduces the tie rod roll that can cause a dead spot of un-resisted movement in the steering. It fits all OEM JK Wrangler tie rods and tie rods with 1-3/8 inch diameter tubing.
Key features
- Moves the stabilizer up nearly 2.5 inch
- 6061 aluminum clamp
- Forged 10.9 stud
- Works with OEM tie rods
- Fits tie rods with 1-3/8 inch diameter tubing
- For 2 and 4-door models
Steering geometry and relocation
A steering stabilizer damps side-to-side movement at the front axle, and it works against the tie rod when the wheels hit uneven ground. Over time the stabilizer shaft and body can take hits from rocks and trail debris. Moving the mount higher changes the angle the damper works through, which is why relocation is a geometry change and not just a bolt-on part.
Tie rod roll is a common source of steering play on lifted Jeeps. When the tie rod flexes, the steering can feel loose for a moment before the wheels respond. Keeping the stabilizer in a more protected position helps limit contact with obstacles, but it does not replace sound tie rod ends or track bar bushings.
After relocation, check steering free play, the tie rod ends and the mounting brackets. Look for rubbing, bent brackets or cracked welds, and recheck fasteners after the first few drives.
- Check steering free play after installation
- Inspect tie rod ends and track bar bushings
- Look for rubbing on the relocated mounts
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1123140 |
| UPC | 843885036210 |
| Relocation height | Nearly 2.5 inch up |
| Clamp material | 6061 aluminum |
| Stud | Forged 10.9 |
| Tie rod tubing | 1-3/8 inch diameter compatible |
| Door models | 2 and 4-door |
Vehicle fitment
This kit is for 2007-2018 Jeep Wrangler JK vehicles, since it fits all OEM JK Wrangler tie rods. Both 2 and 4-door models are covered.
Other Wrangler generations, including the TJ, LJ and JL, are not covered by this statement. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check that your tie rod is OEM or has 1-3/8 inch diameter tubing before installing the kit. Moving the stabilizer changes its position, so inspect the steering components after installation.
What’s included
The 6061 aluminum clamp and forged 10.9 stud come with the kit.
Not included: the steering stabilizer itself, which the kit repositions.







