Overview
The Rancho RS5509 is a mount-only steering stabilizer bracket for a Dana 44 axle, supplied with the hardware needed to complete installation on some Rancho steering stabilizers. The stabilizer itself is not included.
The bracket is sized at 2-3/4 inch, 75mm O.D. Confirm the axle and bracket size against your own setup before installing.
Key features
- Mount-only steering stabilizer bracket
- Hardware included to complete installation on some Rancho stabilizers
- Dana 44 axle application
- Listed at 2-3/4 inch, 75mm O.D.
Mounts and bushings explained
A steering stabilizer mount carries the shock’s load into the axle or frame, so it takes repeated force every time the wheels move. The mount’s shape, fastener pattern and bushing fit all matter. A bracket that is slightly off can put the stabilizer under side load, which wears the shock eye and the bracket faster than normal.
Bushings and eyes at the stabilizer ends are a common wear point. A worn bushing lets the stabilizer rattle or knock at the mount, and it can change how the steering responds at low speed. Replacing the bushing while the bracket is off the vehicle is often easier than doing it later.
Mounting hardware should be checked during any install. Look at bolt holes for elongation, welds for cracks and the axle tube for damage around the bracket. Clean the surfaces before fitting, and match the grade of any replacement fasteners to the originals.
- Check welds and clamp bolts for cracks
- Look for elongated bolt holes
- Replace worn stabilizer end bushings
- Match the stabilizer eye size to the mount
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS5509 |
| UPC | 39703550901 |
| Type | Mount only |
| Single / dual | Single |
| Brackets | Included |
| Shock boot | Not included |
| Axle | Dana 44 |
| Size | 2-3/4 inch, 75mm O.D. |
| Hardware | Included with the bracket set |
Vehicle fitment
It is made for the Dana 44 axle, so confirm the axle type on your vehicle along with the year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The hardware is intended for some Rancho stabilizers, so confirm your stabilizer model is one of them before mounting. Check that the 2-3/4 inch, 75mm O.D. size matches your axle before tightening anything.
What’s included
Mounting bracket and included hardware.
Not included: the steering stabilizer and shock boot.







