Overview
The Curt Manufacturing 83742 is a surface mounted D-ring tie-down anchor, a heavy-duty steel ring for securing straps, ropes, cables or chains to a trailer, truck bed or full-size van. It is rated at 11,000 lbs. and built from forged steel for demanding loads. It is a universal fit, so it is not a vehicle-specific part.
Unsecured cargo can shift, damaging the load and the vehicle and endangering the people around it. This D-ring gives you a solid point to attach cargo straps or chain. The ring has a large opening for clevis hooks, and the thick metal bracket is set up for surface mounting with square holes for carriage bolts. Use the 11,000 lbs. rating as the upper figure when you plan a tie-down, and do not load the ring beyond it.
Key features
- Forged steel construction
- Heavy-duty ring with a large opening for clevis hooks
- Thick metal bracket with square mounting holes for carriage bolts
- Corrosion-resistant yellow zinc plating
- Can be mounted with the bracket alone or with backing plate #83607 or #83610
- Rated capacity of 11,000 lbs.
Mounting Surface Checks
A D-ring is only as secure as the metal it is fastened to. Before mounting, inspect the surface for rust, cracks and thin sections, and make sure there is clear room behind it for nuts and washers. Plate or frame sections that flex will loosen bolts over time, so a reinforced area is the better choice for heavy straps.
Once fastened, recheck the bolts after the first few uses. Vibration on a trailer or truck bed can loosen hardware, and wet or salty conditions can corrode bolts and the anchor finish. Look for chips in the zinc plating, and touch up exposed metal so rust does not spread under the bracket.
- Inspect the mounting surface for rust and cracks
- Choose carriage bolts that fit the square holes
- Recheck bolts after the first few uses
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | 83742 |
| UPC | 612314070428 |
| Type | Surface mounted D-ring tie-down anchor |
| Capacity | 11,000 lbs. |
| Material | Forged steel |
| Finish | Yellow zinc plating |
| Bracket size | 1-3/4″ x 3-11/16″ x 7/8″ |
| Ring size | 3-1/2″ x 3-1/2″ x 1/2″ |
| Mounting holes | Square holes accept 3/8″ carriage bolts; 7/16″ mounting holes spaced 2″ apart, center to center |
| Compatible backing plates | #83607 or #83610 |
Vehicle fitment
It fits trailers, trucks and full-size vans, and it is not built for one particular make, model or year. Fit depends on the mounting surface and bolt pattern, so check that the bracket holes match your bolts and that the mounting location can take the load.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Mounting bolts are not included, so choose carriage bolts that suit the 3/8″ square holes and the 7/16″ mounting holes before you start. The bracket can be mounted alone or with backing plate #83607 or #83610, so pick the setup that suits your surface. Make sure the anchor is fastened securely before you load straps against it.
What’s included
The surface mounted D-ring anchor with its bracket.
Not included: Mounting bolts are not included. Backing plates #83607 and #83610 are separate parts.












