Overview
The Superchips LIT E-Series LED Flood Light Pods with Power Switch, part number SCI72081, is a kit of square LED flood light pods with a power switch for the TrailDash monitor. The pods use a flood beam, which spreads light over a wide area near the vehicle, so they are suited to close-range lighting rather than long-distance reach.
The driver switches the pods from the TrailDash accessory port, and a relay harness runs from the switch to the battery. The switch leaves a spare circuit, so another light or a 12-volt accessory can run from the same switch. Routing everything through one switch keeps the dash free of added switch panels.
The kit uses the LIT E-Series power switch accessory, the same accessory Superchips offers with its single-row light bars. Pairing pods and a bar through one switch lets the driver manage the lights from one place, and the kit leaves room on that switch for another circuit.
Key features
- Square LED flood light pods in a kit
- Flood beam pattern for wide, close-range light
- Power switch accessory for the TrailDash accessory port
- Included relay harness for a battery connection
- Spare switch circuit for another accessory
Flood lighting use and placement
Flood pods trade reach for width. Their light fills the ground beside and just ahead of the vehicle, which helps when setting up camp, loading gear, hooking up a trailer or working on a tire at night. Because the beam is wide rather than long, placing the pods low and angled slightly down usually gives more useful light than aiming them at the horizon. Keep the lenses clean, since mud and road film cut output quickly in a wide beam.
Pods are often paired with a longer light for trail work. A flood pattern covers the near area and the sides of the trail, while a spot or combo beam reaches farther down the path. Think about the mounting spots first: a pod on a rear bumper or a roof rack lights the work area behind the vehicle, while front-mounted pods help when crawling over obstacles. Plan the cable route before drilling and keep the connections above the splash zone where possible.
- Angle pods slightly down to light the work area
- Wipe lenses after mud or dust exposure
- Check that the harness clears moving parts before tightening
Specifications
| Brand | Superchips |
|---|---|
| Part number | SCI72081 |
| Product line | LIT E-Series LED flood pods with power switch |
| Sold as | Kit |
| Light type | LED light pod |
| Light shape | Square |
| Beam pattern | Flood |
| Bulb type | LED |
| Control | Power switch for the TrailDash accessory port |
| Finish | Black |
Vehicle fitment
The pods and power switch are a universal fit, so they are not built for one vehicle. The TrailDash monitor is the piece that sets the installation, because the switch uses its accessory port.
Installation notes
Run the power switch to the TrailDash accessory port and connect the relay harness to the battery. Mount the pods where the flood beam is needed, and keep the wiring fused and clear of heat and moving parts.
What’s included
The kit includes the flood light pods, the power switch accessory and the relay harness. The TrailDash monitor is needed for the switch and is not included.
Not included: TrailDash monitor.
















