Overview
The Superchips LIT E-Series 30 inch Single Row LED Combo Light Bar with Power Switch, part number SCI72031, is a 30-inch single-row LED light bar with a combo beam and a power switch for the TrailDash or TrailDash2 monitor. The power switch lets the driver run the bar from the dash without a separate switch panel.
Superchips supplies the kit as a plug-and-play package. The power switch plugs into the monitor’s accessory port, and the included relay harness runs from the switch to the battery. The switch can also control another circuit, so a second light or an air compressor can be wired through the same accessory port.
The single-row housing belongs to the LIT E-Series, which comes in several lengths from the LIT 6 to the LIT 50. The 30-inch version is a longer bar in that line, and its combo pattern gives both close coverage and reach down the trail. The package helps keep the dash clean while adding light.
Key features
- 30-inch single-row bar with a combo beam
- Power switch accessory for the TrailDash or TrailDash2 monitor
- Included relay harness for the battery connection
- Spare circuit for another 12-volt accessory
- Designed to avoid cutting into the factory dash for switch panels
Choosing between bar lengths
A longer bar spreads light over a wider area in front of the vehicle, but it needs more room to mount and more space for its harness. Measure the mounting surface before buying and think about whether the bar will sit low on a bumper or higher on a roof or roll bar, since mounting height changes how the light falls on the trail.
Whatever length is chosen, the power switch and relay harness are the same parts of the setup. Keep the harness fused at the battery, avoid sharp bends, and check that the bar is secure after rough use. Clean the lens and look for any moisture inside the housing after wet outings.
- Measure the mounting area before ordering
- Consider mounting height for the beam pattern
- Re-check the bracket after rough trails
Specifications
| Brand | Superchips |
|---|---|
| Part number | SCI72031 |
| Product line | LIT E-Series single row with power switch |
| Light type | LED light bar, sold as a single bar |
| Size | 30 inch |
| Beam pattern | Combo |
| Bulb type | LED |
| Control | Power switch for the TrailDash or TrailDash2 accessory port |
| Finish | Black |
Vehicle fitment
The light bar and power switch are a universal fit and are not built for a single vehicle. The setup depends mainly on the TrailDash or TrailDash2 monitor, because the switch runs from that monitor’s accessory port.
Check that your monitor model is a TrailDash or TrailDash2 before fitting.
Installation notes
Plug the power switch into the monitor’s accessory port and run the relay harness to the battery. Keep the harness fused at the battery and route it away from heat and moving parts.
What’s included
The kit includes the 30-inch light bar, the power switch accessory and the relay harness. The TrailDash or TrailDash2 monitor is required for the accessory port and is not included.
Not included: TrailDash or TrailDash2 monitor.















