Overview
The Smittybilt XRC front bumper package, part number XRCTJ1, is a set of XRC series bumpers finished in two-stage textured matte black powder coat on 3/16-inch cold rolled steel. It carries a 5-year limited warranty and includes a front stinger, a rear bumper and a swing-away tire carrier.
The XRC bumpers have high approach angles and raised corners for ground clearance. Welds are applied robotically, then ground down and smoothed before the two-stage powder coat. The bumpers are designed as complete bolt-on units that need no vehicle modifications.
The front stinger is built from 1.75-inch tubing with two light tabs that hold up to two 9-inch lights. Smittybilt says its design can mount a winch up to 10,000 lb, with the option of an aluminum or roller fairlead. The rear bumper has a built-in Class III receiver hitch and two solid D-ring mounts welded on the inside and out. The tire carrier has a billet handle with a camlock system, an adjustable tire mount and a safety catch that holds the swing-away open while parked or at any angle.
Key features
- Two-stage textured matte black powder coat on 3/16-inch cold rolled steel
- High degree approach angles and raised corners
- Welds ground down and smoothed before finishing
- Front stinger from 1.75-inch tubing with two light tabs
- Designed to mount a winch up to 10,000 lb with aluminum or roller fairlead
- Rear bumper with built-in Class III receiver hitch
- Two solid D-ring mounts welded inside and out
- Complete bolt-on that needs no vehicle modification
- 5-year limited warranty
Winch and light planning
The front stinger carries the winch and the lights, so its load goes straight into the frame and mounting points. Choose a winch within the 10,000 lb capacity the design supports, and keep the cable line straight through the fairlead to reduce side load. Lights on the tabs need a wiring plan of their own. Run their feed through a fused relay and keep the harness clear of the winch and moving parts.
The rear bumper and swing-away tire carrier add weight to the back of the vehicle. Check that the carrier clears the rear door, the tailgate and any spare tire swing before you drive off. Recheck all fasteners after the first off-road trip, since bumpers see twisting and impact loads that settle bolts over time. Touch up any chips in the powder coat quickly to keep bare steel from rusting.
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | XRCTJ1 |
| UPC | 70000563205 |
| Product | XRC front bumper package |
| Material | Cold rolled steel, 3/16 in |
| Finish | Two-stage textured matte black powder coat |
| Front stinger tubing | 1.75 in |
| Light tabs | Two, each holding up to two 9 in lights |
| Winch capacity | Up to 10,000 lb |
| Rear hitch | Built-in Class III receiver |
| Width | Full |
| Fit type | Direct fit, bolt-on |
| Warranty | 5-year limited |
Vehicle fitment
Check fit for your vehicle’s year, model and trim before ordering.
The TJ in the part number is not a stated vehicle, so do not use it to assume a Wrangler fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The bumpers bolt on and need no modifications to the vehicle. If you fit lights on the tabs, wire them through a fused relay, and choose a winch rated within the 10,000 lb capacity Smittybilt states.
What’s included
- XRC front bumper with stinger and winch mount
- Rear bumper with Class III receiver and D-ring mounts
- Swing-away tire carrier with camlock handle
Not included: a winch, fairlead, lights and the tire.


















