Overview
The Smittybilt M1 612822 is a black powder coated front bumper made from 3/16″ cold rolled steel with 1/4″ mounting plates. It has a built-in winch plate, 7/8 inch solid D-ring mounts, and Ultra Bright driving and fog lights.
The solid plate center section wraps the frame horns and the lower crossmember. The winch mount system is built to hold a winch up to 16,500 lb, and the bumper bolts on without drilling. The black finish is a two stage Signature Series powder coat.
Key features
- Built-in winch plate, winch mount system for up to 16,500 lb
- 7/8 inch solid D-ring mounts welded inside and out
- Ultra Bright driving lights and fog lights
- Solid plate center section wrapping the frame horns and lower crossmember
- 3/16″ cold rolled steel with 1/4″ mounting plates
- Signature series two stage powder coat
Before you buy
A winch bumper changes how a truck carries load at the front end. The bumper takes the pull from a winch, so the mounting points and frame connection matter more than the look of the bumper. Before buying, think about the winch you plan to run, since the mount system is built around a winch up to 16,500 lb and a heavier unit adds weight to the front axle. Consider the front of your truck too: a steel bumper with lights and a winch adds weight, which can change steering and braking feel and may reduce approach angle on steep trails.
Owners who fit a winch often add a skid plate, a hydraulic jack or a lower-mount fairlead in the same job, since those parts are commonly added or replaced together. Inspect the mounting bolts and plate welds after the first few trail runs and again each season. Powder coat can chip where straps and tree contact the bumper, so touch up exposed steel early to slow rust.
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 612822 |
| UPC | 631410119893 |
| Series | M1 front bumper |
| Material | Cold rolled steel, 3/16″ with 1/4″ mounting plates |
| Finish | Black two stage powder coat |
| Maximum winch | 16,500 lb |
| D-ring mounts | 7/8 inch, solid |
| Lights | Ultra Bright driving and fog lights |
| Installation | Bolt-on, no drilling |
Vehicle fitment
Confirm fit for your vehicle’s year, model and trim before ordering.
Match the bumper to your truck’s year, model and trim, then compare the mounting points with your frame before buying.
What’s included
- M1 front bumper with built-in winch plate
- 7/8 inch solid D-ring mounts
- Ultra Bright driving lights and fog lights
Not included: a winch and fairlead.




















