Overview
The Skyjacker TCR25S is a rear Softride leaf spring for the 1998–2004 Toyota Tacoma in Base, Limited, Pre Runner and SR5 trims. It is a single spring, so order a second unit for a pair.
The spring is preset and formed from 5160H chromium alloy, which Skyjacker says gives higher tensile strength and longer life. The powder coat is meant to resist corrosion, and rubber bushings come pre-installed. Skyjacker rates the spring for a lift height range of 0 to 4.99 inches.
Key features
- Preset and formed from 5160H chromium alloy
- Powder coated to resist corrosion
- Rubber bushings pre-installed
- Single rear spring; a pair needs a second unit
- Lift height range 0 to 4.99 inches
- Coils are available separately
- Limited lifetime warranty
Signs a leaf spring needs replacing
Leaf springs on a Tacoma rear axle work every time the truck loads or unloads. Over time the leaves lose arc, and the rear sags so the bed sits lower with the same cargo. A tired spring can also let the axle wander or cause the rear to squat more than usual under acceleration. Look at the spring from the side and compare it with the opposite side.
Inspect the spring pack for cracked or broken leaves, and check the center bolt and clamp bolts for looseness. Powder coating helps resist surface rust, but a scraped or pitted area should be cleaned and checked. Replace the bushings at the eye and shackle when the spring is out, and keep U-bolt nuts tight after the first drives.
- Check rear height on both sides
- Look for cracked or broken leaves
- Inspect the center bolt and clamps
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | TCR25S |
| UPC | 803696169781 |
| Position | Rear |
| Spring quantity | Single spring |
| Bushings | Rubber bushings, pre-installed |
| Material | 5160H chromium alloy |
| Finish | Powder coated |
| Lift height range | 0 to 4.99 inches |
| Fitment type | Direct fit |
| Warranty | Limited lifetime |
Vehicle fitment
It is a direct fit for the 1998–2004 Toyota Tacoma in Base, Limited, Pre Runner and SR5 trims.
The fit covers the 1998–2004 Tacoma generation only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rubber bushings come pre-installed, so no separate bushing set is mentioned for this spring. Replacing a leaf spring shifts ride height and axle position, so have the alignment checked once the spring is in place.
What’s included
One rear leaf spring with rubber bushings pre-installed.






