Overview
The Rugged Ridge 18760.06 is a 28 tooth long shaft speedometer gear for cable speedometers. It fits 84-93 Jeep Cherokee, 55-86 CJ, 86-92 Comanche, 93 Grand Cherokee and 87-93 Wrangler models with cable speedometers.
It is a direct replacement with easy installation, and no drilling is required.
Key features
- 28 tooth count
- Long shaft design
- Cable speedometer application
- No drilling required
- Direct replacement with easy installation, per the manufacturer
Cable speedometer basics
A cable speedometer takes its signal from a flexible cable that runs from the transmission or transfer case to the gauge. The gear at the drive end turns the cable, so the tooth count and shaft length have to match the speed the gauge is calibrated for. Mismatched gears usually show up as a reading that is consistently high or low.
Before replacing a gear, check that the speedometer is actually cable-driven and look at the cable housing for kinks or wear. A worn cable can read erratically even with a correct gear. If the old gear is damaged, replace the cable at the same time to avoid repeat trips.
- Confirm the speedometer is cable-driven
- Check the cable for kinks or stiffness
- Match the gear’s shaft length to the old one
- Replace the cable with the gear if it is worn
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 18760.06 |
| UPC | 804314254476 |
| Tooth count | 28 |
| Shaft length | Long |
| Speedometer type | Cable |
Vehicle fitment
The gear fits Cherokee 84-93, CJ 55-86, Comanche 86-92, Grand Cherokee 93 and Wrangler 87-93 with cable speedometers.
Electrically driven speedometers on 93-01 Cherokee or 93-06 Wrangler models are not the match for this cable gear. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the speedometer is cable-driven before fitting this gear, since no drilling is required.
What’s included
Check the package contents against your installation before starting.












