Overview
The Rugged Ridge 18760.09 is a 30 tooth short shaft speedometer gear made to fit electrically driven speedometers on 93-01 Cherokee, 93-98 Grand Cherokee and 93-06 Wrangler models. It is presented as a direct OE replacement for the factory gear.
Owners looking for a 30 tooth speedometer drive gear can confirm the tooth count and shaft length in the specifications below.
Key features
- 30 tooth count
- Short shaft design
- Direct OE replacement
- Bolt-on installation
- Built for electrically driven speedometers
Electric speedometer care
An electric speedometer relies on a steady pulse from the drive gear, so the gear and its mating housing both need to be sound. A 30 tooth gear gives a specific speed signal, so it must match the gauge and the drive it replaces. Gear teeth that are chipped or worn can send a weak pulse, which shows up as jumpy or missing readings at speed.
During service, clean the gear and housing area before fitting the new gear, and check the seal for leaks. Keep the sensor wiring away from moving parts. A correctly matched gear should give a steady reading without extra adjustment.
- Check tooth count against the old gear
- Clean the housing before installation
- Inspect the seal for seepage
- Recheck the reading after a short test drive
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 18760.09 |
| UPC | 804314254506 |
| Gear type | Speedometer drive gear, short shaft |
| Tooth count | 30 tooth |
| Speedometer type | Electrically driven |
Vehicle fitment
It fits 93-01 Cherokee, 93-98 Grand Cherokee and 93-06 Wrangler vehicles with electrically driven speedometers. The gear is matched to these vehicles, so check the fit against your year, model and trim.
Cable-speedometer vehicles and years outside these ranges are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The package is the single 30 tooth short shaft gear. Check the package contents against your installation before starting.












