Overview
The Rugged Ridge 18305.21 is a front track bar relocation bracket for 2007–2018 Jeep Wrangler JK models with a 4-inch lift. It is a heavy-duty steel bracket that moves the front track bar mount and bolts on for a direct fit.
It fits 2007–2018 Jeep Wrangler JK models in the trims below, including Unlimited versions.
Key features
- Heavy-duty steel construction
- Bolt-on application for a direct fit
- No drilling or modification is needed.
- Front position relocation bracket
- Designed for a 4-inch lift
Front track bar geometry
A front track bar holds the axle laterally, and a lift changes the angle it runs at. A relocation bracket moves the mount so the bar can sit closer to level again, which helps reduce steering wander and axle shift over rough ground. Because the bar ends pivot through the arc of suspension travel, the geometry is always a compromise, so the bracket’s placement matters.
When a bracket is in place, check the bar’s bushings, ends and mounting bolts for wear. Look for cracks around the bracket welds, looseness at the frame connection, and any scraping from the bar against nearby parts. Front alignment is normally required after a relocation, and the hardware should be re-torqued after the first few drives. Keep an eye on steering response afterward.
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 18305.21 |
| UPC | 804314221027 |
| Position | Front |
| Lift | 4 inches |
| Material | Heavy-duty steel |
| Installation | Bolt-on |
Vehicle fitment
It fits 2007–2018 Jeep Wrangler (JK) in the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims, including the Unlimited versions of those trims.
This bracket is for the front position only and is not a rear track bar. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
No drilling or modification is needed, so installation is bolt-on. Check that your lift height is close to 4 inches, then have the front alignment checked after installation.
What’s included
Hardware inclusion is unconfirmed, so check the package contents against your installation before starting.
Not included: Track bar and axle hardware are unconfirmed for this package, so confirm what you need before installing.









