Overview
The Rugged Ridge Center Console Switch Panel (part number 17235.55) is a switch plate built for 2007-2010 Jeep Wrangler (JK) models with an automatic transmission. It replaces the factory center console filler plate and holds up to four switches within easy reach of the driver.
It is custom built for the automatic transmission center console. Manual transmission vehicles are not covered.
Key features
- Replaces the factory center console filler plate
- Holds up to four switches
- Custom built for 2007-2010 Jeep Wrangler with an automatic transmission
- Filler plate pops out and the switch plate takes its place
- Limited 5 year warranty
Console switch planning
A center console switch plate sits in a crowded area that holds the shifter, cup holders and sometimes the parking brake lever. Before installing, check that the plate seats fully, that the console lid closes without catching, and that the shifter boot moves freely. Mark the switch layout with the console open so the wiring path is clear.
Wiring a console plate takes more care than a dash panel because the space behind it is tight. Use short leads with clean connectors, and keep them away from transmission tunnel heat and the shifter linkage. Fused circuits protect each accessory, and each fuse should sit close to its power source. Re-check the plate after a few weeks of driving, since console parts can shift with use.
- Check the shifter boot clearance before fastening
- Keep wiring away from heat and linkage
- Fuse each accessory circuit near its power source
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 17235.55 |
| UPC | 804314228576 |
| Switch capacity | Up to 4 switches |
| Application | Center console, 2007-2010 Jeep Wrangler (JK) with automatic transmission |
| Warranty | Limited 5 year |
Vehicle fitment
It is built for 2007 to 2010 Jeep Wrangler (JK) models with an automatic transmission.
Manual transmission vehicles and other Wrangler generations (TJ, LJ, JL) are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Remove the factory filler plate by popping it out, then set the switch plate in its place. Because the plate sits in the console opening, check the fit before wiring any switches.
What’s included
Switches are not included, so plan on supplying your own rocker switches.









