Overview
The Rugged Ridge A-Pillar Pod Kit, part number 17235.88, is a 4-switch accessory kit built around an A-pillar pod. The kit contains the pod (17235.56), 3 marine style 2-position rocker switches in red, amber and blue, and a combo rocker switch USB connector (17235.05).
The pod has a textured molded finish meant to match the factory plastic pillar cover it replaces, and it snaps into place for a factory look. Fitment is given as direct fit, with no vehicle years or models named.
Key features
- 4-switch kit with pod and rocker switches
- 3 marine style 2-position rocker switches in red, amber and blue
- Combo rocker switch USB connector included
- Textured molded finish like the factory plastic pillar cover
- Snap-in mounting for a factory look
Power and USB wiring
A multi-switch A-pillar kit puts several loads on the dash, so plan how each switch will be powered before installing the pod. Each rocker switch should run through its own fused circuit, and the USB connector should be wired to a switched feed so it can shut off with the ignition. Sketch the routing from the pillar to the fuse panel, noting where each wire will pass.
Color-coded switches are easy to identify at night, but labeling the wires matters more. Mark both ends of every circuit, and keep the USB cable and rocker switch wires separated so charging cables do not catch on the switch harness. Check the grounds at the pod and at the chassis for good contact, since weak grounds cause flickering on lighted switches.
- Size each fuse to its load
- Route the USB feed separately from switch wires
- Test each switch before closing the trim
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 17235.88 |
| UPC | 804314288037 |
| Switch count | 4 |
| Pod part number | 17235.56 |
| USB connector switch part number | 17235.05 |
| Rocker switch type | 3 marine style, 2-position |
| Rocker switch colors | Red, amber, blue |
| Finish | Textured molded |
Vehicle fitment
This kit has no vehicle years, makes, models or trims listed. Rugged Ridge gives direct fit as its only fitment note, so the vehicles it works with have to be confirmed separately.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The pod snaps into place without drilling. The three rocker switches and the USB connector need a fused power connection, so plan that wiring before installing the pod.
What’s included
The kit includes an A-pillar pod (17235.56), 3 marine style 2-position rocker switches (1 each, red, amber and blue), and a combo rocker switch USB connector (17235.05).
Not included: Plan on supplying your own wiring and any mounting hardware beyond the snap-in pod.












