Overview
The Rugged Ridge 2-Position Rocker Switch (Passenger Eject), part 17235.13, is a laser-etched rocker switch for controlling electrical lights and accessories inside a vehicle. This version carries the Passenger Eject label.
The switch is universal fit. Its 3-terminal hook-up lets it be used in virtually any Jeep, truck, SUV or car, provided there is room for a switch panel and a circuit to control.
Key features
- Two-position rocker switch with a laser-etched logo that identifies the function it controls
- Rated for 20 amps
- Amber LED illumination when the switch is in the ON position
- 3-terminal hook-up
- Logo examples include Rock Lights, Off-Road Lights, Light Bar, Lighted Whip, Apocalypse Lights, Sasquatch Lights and Zombie Lights
- Not waterproof
Wiring a rocker switch safely
A rocker switch is only the control point, so the wiring behind it decides how safely the system runs. Before cutting into a circuit, identify a switched power source that matches the job, such as an accessory circuit, and confirm it is protected by a fuse. Disconnect the battery before running new wire. Mount the switch where you can reach it without looking, and route the wire away from moving parts, sharp edges and the pedals.
Wire the switch so the lamp draws current through a relay wherever the load is significant. The relay carries the heavy current, while the switch only signals it, which keeps the switch from overheating. Use wire sized for the load and keep connections tight and covered, especially in damp areas of the vehicle. Test each function with the engine off before you close up the dash panel.
- Label the switch function clearly so the right light is controlled
- Keep the LED wired to a circuit that matches its ON state
- Recheck terminal connections after the first few drives over rough ground
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | RUG17235.13 |
| Switch type | Rocker, 2-position |
| Label | Passenger Eject |
| Current rating | 20 amps |
| Illumination | Amber / orange LED, lit when ON |
| Terminals | 3 |
| Waterproof | No |
| Fitment | Universal fit |
Vehicle fitment
This switch is universal fit and is not built for one vehicle. It works in Jeeps, trucks, SUVs and cars that have a free switch position and a circuit that can be wired to it.
Because the switch is not waterproof, mount it inside the cabin rather than in an exposed location. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Run lights that draw more than the switch’s 20-amp rating through a fused relay, and keep the switch itself within that limit. Check local rules on auxiliary lights before using them on public roads.
What’s included
The rocker switch with its laser-etched logo and 3-terminal hook-up.
Not included: the lights and accessories the switch controls, and any relay or wiring you add.










