Overview
The Rubicon Express RE9990 is a front steering stabilizer bracket sold as a mount only. It is laser cut from 3/16 inch cold rolled steel and then CNC formed. It arrives as bare steel and needs welding to the axle, which suits mounting a custom axle in a rig.
The bracket fits the 2004-2006 Jeep Wrangler LJ in the Unlimited and Unlimited Rubicon trims, and the 1997-2006 Jeep Wrangler TJ in the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims. The mount is positioned at the front and supplied as mount only, not as a full stabilizer kit.
Key features
- Front steering stabilizer mount
- Laser cut from 3/16 inch cold rolled steel
- CNC formed
- Bare steel finish
- Welding required for installation
- Mount only, with brackets included.
Welding and mounting a bare bracket
A bare steel mount is a blank for the installer to finish. Because it arrives unpainted and unwelded, the surface must be cleaned of mill scale, oil and paint before welding, and the weld should be done by someone comfortable with steel fabrication. A clean, square mounting surface makes the bracket easier to set straight.
Welds on axle tubes and mounts take stress from steering loads and trail impacts, so the joint should be checked after the first few drives. Look for cracks, porosity and any movement at the weld edge. Heat can distort the bracket, so check the steering geometry again once everything has cooled.
After welding, paint or coat the bracket to slow corrosion, especially on a vehicle that sees mud and water. Recheck the stabilizer clearance at full lock, and confirm the stabilizer still moves freely through its range.
- Clean the surface before welding
- Check the weld after the first drives
- Coat the bracket after fabrication
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE9990 |
| Listed part code | RE9990, with R/ERE9990 as the alternate code |
| UPC | 614901442519 |
| Position | Front |
| Type | Mount only |
| Material | 3/16 inch cold rolled steel |
| Finish | Bare steel |
| Installation | Welding required |
Vehicle fitment
It fits the 2004-2006 Jeep Wrangler LJ in the Unlimited and Unlimited Rubicon trims, and the 1997-2006 Jeep Wrangler TJ in the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
Other Wrangler generations are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the bracket is bare steel, it must be welded in place, so the install needs a welder and a clean mounting surface. Check the stabilizer geometry and the steering clearance at full lock once the bracket is set.
What’s included
The package is the front steering stabilizer mount. The shock boot is not included.








