Overview
The Pro Comp Suspension 2535 is a single steering stabilizer bracket kit. It is a mount-only kit, so it is used to attach an ES2000 steering stabilizer shock to the vehicle. The kit includes the bracket and mounting hardware and is boxed for one cylinder.
The bracket kit is the mounting hardware used to install an ES2000 steering stabilizer shock on the vehicle. Confirm the application for your vehicle before ordering.
Key features
- Mount-only bracket kit for one cylinder
- Includes bracket and mounting hardware
- Boxed for single cylinder use
- Direct-fit type listed
Mounting a stabilizer shock
A bracket kit provides the mounting points that connect a steering stabilizer shock to the axle and the frame or steering linkage. Its job is to hold the shock at the correct angle so it extends and compresses along its full travel without binding. Poor mounting angles can wear the shock eyes early and reduce damping.
Before installation, compare the bracket hardware with the shock ends and confirm the stud and eye sizes match. Clean the mounting surfaces, tighten fasteners to the torque for the hardware in use, and recheck them after the first few trail runs. Inspect the bracket welds and bushings at each service interval, and replace any bent or cracked part before it lets the shock move out of line.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 2535 |
| UPC | 614901030297 |
| Type | Mount only |
| Cylinder count | Single |
| Brackets | Included |
| Hardware | Mounting hardware included |
| Fitment type | Direct fit |
Vehicle fitment
Make sure the application matches your truck’s year, model and trim before buying. This kit is for mounting a single cylinder only; it does not include the stabilizer shock.
This kit is for mounting a single cylinder only; it does not include the stabilizer shock.
What’s included
One bracket kit with mounting hardware.
Not included: the ES2000 stabilizer shock.








