Overview
The Rough Country 4-inch long arm suspension lift kit with N3 shocks, part number R/C61930, fits four-door 2018–2026 Jeep Wrangler (JL) Unlimited models, including Sport, Sahara, Rubicon, Willys and High Altitude versions. It uses a four-link setup that keeps suspension geometry close to factory angles.
The kit includes front and rear coil springs, which the brand describes as custom engineered dual-rate coils. The dual rate gives two different levels of compression, so the suspension works differently at the start of its travel than near the end. The kit also includes N3 shocks at the front and rear.
Installation is simpler than many long arm setups because it requires no welding and no removal of the factory crossmember. The kit provides a lift height range of 4 to 5.5 inches.
Key features
- Four-link setup for flex and articulation
- Adjustable upper and lower control arms front and rear
- Adjustable flex joints with Clevite rubber bushings
- Heavy-wall DOM tubing for the arms
- Brackets made of 1/4-inch high tensile plate steel
- Dual-rate coils and N3 shocks
Setting up long arms
A long arm kit moves the axle location, so the arms become the main way to set the geometry. Four-link designs control the axle with separate upper and lower arms, which is why the adjustment points matter. Set the pinion angle and wheelbase carefully, since small changes at the arms affect driveline angles, tire position and steering feel.
After installation, have the alignment checked and confirm the driveline angles before taking the truck off road. Dual-rate coils change how the suspension responds at the start and end of its travel, so test the ride at low speed first. Check the plate steel brackets, Clevite bushings and N3 shocks for wear, and recheck the arm hardware after the first few drives.
Specifications
| Brand | Rough Country |
|---|---|
| Part number | R/C61930 |
| Lift kit | 4 to 4.5 inches |
| Suspension type | Four-link long arm |
| Control arm tubing | Heavy-wall DOM |
| Bracket steel | 1/4-inch high tensile plate steel |
| Bushings | Clevite rubber |
| Rear lift component | Coil spring |
| Front shocks | N3 |
| Rear shocks | N3 |
| Lift height range | 4 to 5.5 inches |
| Fitment type | Direct fit |
Vehicle fitment
It fits the four-door 2018–2026 Jeep Wrangler (JL) Unlimited, including the 80th Anniversary, Freedom, High Altitude, Islander, Moab, Rubicon, Rubicon 392, Rubicon 4xe, Sahara, Sport, Sport Altitude, Sport S and Willys versions.
Two-door Wrangler JL models and the Wrangler JK and JT generations are not on the list.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A long arm kit changes the axle location and the driveline angles, so the pinion angle and the wheelbase should be set on the adjustable arms during installation. Have the alignment checked afterward and confirm the driveline angles before going off road.
What’s included
A full set of front and rear upper and lower adjustable control arms, dual-rate coils, Clevite bushings, N3 front and rear shocks, and the plate steel brackets.















