Overview
The Rock Hard 4×4 Parts RH-1001-F is a set of rear angle bars for the Rock Hard 4×4 sport cage. The bars use 1-3/4 inch x.120 wall tubing and come unpainted in bare steel.
The manufacturer fitment list places them on the 2004-2006 Jeep Wrangler LJ, including the Unlimited and Unlimited Rubicon trims, and on the 2004-2006 Jeep Wrangler TJ with 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
Key features
- Bolt-in installation type
- 1-3/4 inch x.120 wall tubing
- Unpainted bare steel
- Made in the U.S.A.
- Direct fit for the Jeep Wrangler LJ and TJ
Care for bare steel bars
Bare steel bars rely on their surface for rust protection, so the first step after fitting is a clean, dry finish. Wipe off mud and salt after trail use, and dry the bars thoroughly before storing the vehicle. Standing water in tube ends can cause rust from the inside out, so check for drain points if the bars sit for long periods.
Rear angle bars take loads from the roof and cage, so inspect the welds and mounting points regularly. Look for cracked paint or rust near the joints, which can signal stress. Touch up small chips with a matching paint, and replace bars that show bending rather than trying to straighten them.
- Rinse after mud or salt exposure
- Check mounts after each season
- Touch up chips before rust spreads
Specifications
| Brand | Rock Hard 4×4 Parts |
|---|---|
| Part number | RH-1001-F |
| UPC | 70000364024 |
| Tubing | 1-3/4 inch x.120 wall |
| Finish | Unpainted bare steel |
| Installation type | Bolt in |
| Origin | Made in the U.S.A. |
Vehicle fitment
It fits the 2004-2006 Jeep Wrangler LJ and 2004-2006 Jeep Wrangler TJ in the trims covered above.
Years outside 2004-2006 are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting.








































