Overview
The Rigid Industries Truck-Lite LED Headlight PWM Anti Flicker Adaptor, model 55006, converts H13 to H4 connections. It has direct plug-in pigtails that connect to the back of a three prong light and to the factory three prong pigtail on a Jeep harness.
It has direct plug-in pigtails, 16 gauge wire and encapsulated circuitry.
Key features
- Direct plug-in pigtails
- 16 gauge wire
- Encapsulated circuitry
- PWM anti flicker design
Headlight adaptors and anti flicker
LED headlight conversions often flicker or trigger warning messages because the vehicle expects the load of a halogen bulb. An anti flicker adaptor sits between the harness and the LED to smooth the signal, so the lights stay steady and the vehicle reads the circuit normally. The adaptor is a small, low-profile part that is usually tucked behind the headlight.
Keep the connections dry and seated fully. Check the pins for corrosion when the headlights are serviced, and make sure the wire is not pinched or rubbing against the bracket. Disconnect the battery before working on any headlight wiring, and check the lights aim after the install.
- Seat each plug fully before testing
- Keep the adaptor out of standing water
- Recheck headlight aim after the install
Specifications
| Brand | Rigid Industries |
|---|---|
| Model | 55006 |
| UPC | 849774001796 |
| Wire gauge | 16 gauge |
| Connector | H13 to H4 |
| Circuitry | Encapsulated |
Vehicle fitment
The pigtails connect to a factory three prong pigtail on a Jeep harness. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Plug the pigtails into the matching connectors so the three prong fittings seat fully. Disconnect the battery before connecting any headlight wiring.









