Overview
The Rancho RS999941 is a rear left Loaded QuickLIFT strut assembly for the 2007–2012 Ford Expedition and Expedition EL in 2WD and 4WD form, built for vehicles without air suspension. It is a gas charged, complete modular unit delivered with its coil spring and upper mounting plate already fitted, so the full strut assembly is swapped as one piece.
Rancho’s Loaded QuickLIFT design is meant to level and raise late-model trucks and SUVs, offering a bolder stance and room for larger wheel and tire packages. The RS9000TMXL damper inside has nine positions that can be set by hand, letting you change ride firmness for rough trails or everyday driving.
Key features
- Complete modular rear left strut with coil spring and upper mount installed
- Gas charged damping in a Quick-Strut assembly
- Nine-position manual adjustability
- Matched to 2007–2012 Ford Expedition and Expedition EL, 2WD and 4WD
- Listed by the manufacturer as a direct fit assembly
- Rancho Limited Lifetime Warranty applies, plus the 90-Day Free-Ride Offer
Before you lift the rear
The rear strut carries part of the vehicle weight and controls how the axle moves over bumps, so swapping one side changes how the rear sits. Because this assembly comes with the spring already installed, the spring is loaded when it is removed. Support the axle and vehicle properly and keep the spring control in mind during removal, especially on a vehicle with heavy loads or a roof rack.
A rear left swap alone can leave the two sides unmatched in height and firmness. Many owners replace both sides together so the rear sits level and the ride stays balanced. Check the rear shock absorbers, bump stops and brake lines for wear while the vehicle is raised, since these parts often need attention at the same time.
- Replace both rear sides together where possible
- Inspect rear bump stops and mounting hardware
- Check brake lines and wiring clearance after installation
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS999941 |
| Product line | quickLIFT Loaded (QuickLift Series) |
| Assembly type | Loaded QuickLift Quick-Strut |
| Hydraulic / gas charged | Gas charged |
| Adjustment | 9 position |
| Position | Rear left |
| Fitment type | Direct fit |
| Included | Coil spring, upper mount and strut |
Vehicle fitment
This rear left assembly fits the 2007–2012 Ford Expedition with Eddie Bauer, Funkmaster Flex Edition, King Ranch, Limited, XL and XLT trims. It also fits the 2007–2012 Ford Expedition EL with Eddie Bauer, King Ranch, Limited, XL and XLT trims. Both cover 2WD and 4WD models without air suspension.
Other positions, including the rear right side, and Expedition model years outside 2007–2012 are not covered by this part number. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the spring stays on this assembly, lift the old strut out only with the vehicle fully supported, and keep hands clear of the spring during removal.
What’s included
One rear left Loaded QuickLIFT strut assembly with the coil spring, upper mount and strut supplied.
Not included: the rear right assembly or any other position. This part covers the rear left only.









