Overview
The Pro Comp 5.5 Inch Rear Lift Block, part number 95-550SDB, is a rear suspension block rated for 5.5 inches of lift. Pro Comp supplies the blocks in pairs and says they are for the rear of a vehicle only.
The block suits the rear of a vehicle only, and its fit depends on the rear spring and axle setup. Confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- 5.5 inch rear lift height
- Sold as a pair
- Rear-only application; Pro Comp advises against riser blocks on the front
Before you install rear blocks
Because these blocks sit at the rear only, the front suspension and steering geometry stay as they are. Plan the install with the truck on level ground and the rear fully supported, so the axle can be positioned evenly. Use new hardware where the kit supplies it, and torque all fasteners to the values in your service manual before driving.
Longer brake lines and a check of the parking brake cable are common follow-up steps when the rear axle moves up. Inspect the driveshaft U-joints after the first few hundred miles, and keep an eye on tire rubbing during turns at full lock. A brief test drive on a quiet road helps spot clunks or vibration early. Drivers who tow or carry heavy loads should recheck the rear hardware more often than usual.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 95-550SDB |
| UPC | 614901126952 |
| Lift | 5.5 in, up |
| Position | Rear |
| Quantity | Pair |
| Fitment | Universal fit |
Vehicle fitment
Confirm fit for your vehicle’s year, model and trim before installing a pair. Check the rear suspension and driveline angles against the new height.
Installation notes
Pro Comp says never to use a riser block on the front of any vehicle. Use these blocks at the rear only.
What’s included
A pair of 5.5 inch rear lift blocks.




