Overview
The Pro Comp K4111B is a 4-inch stage 2 coil spring lift with ES3000 front and rear shocks. It fits 1981–1989 Ford F-150 trucks and gives a lift height range of 3 to 4.99 inches.
The front uses coil springs with radius arms and I beam brackets, and the rear is raised with a block and U-bolt kit. A pitman arm corrects the steering, and extended length SS brake lines are included. The shock boots are not included.
Key features
- 4-inch lift, stage 2 design
- Front coil springs with radius arms
- I beam brackets
- Pitman arm steering correction
- Extended length SS brake lines
- Rear block and U-bolt lift
Stage 2 considerations
Stage 2 kits raise the front with radius arms, which changes how the axle sits compared with a bracket-only setup. That geometry is the reason the front alignment needs a careful check once the truck is back on the ground. The rear block and U-bolt lift shifts the driveline angle, so a pinion check is a sensible step after the install, especially on a truck that carries loads often.
Think about how the truck is used before choosing between a basic lift and one with more front hardware. Shock travel matters on rough trails, and a worn steering box or tie rod ends are often replaced while the front end is apart. Inspect the bushings and the brake hose routing at each service interval, because movement at those points is an early sign that the setup needs attention.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | K4111B |
| UPC | 614901125368 |
| Lift | 4 inches, stage 2 |
| Lift height range | 3 to 4.99 inches |
| Suspension type | Radius arm |
| Front lift | Coil springs with radius arms and I beam brackets |
| Rear lift | Block and U-bolt kit |
| Steering correction | Pitman arm |
| Front shocks | ES3000 |
| Rear shocks | ES3000 |
| Brake lines | Extended length SS |
| Shock boots | Not included |
Vehicle fitment
Coverage is 1981–1989 Ford F-150 trucks. Bronco models and other model years are not covered.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Radius arms and I beam brackets change the front geometry, so set the alignment after installation. The rear block and U-bolt lift changes the driveline angles, which should be checked once the truck is back on the ground.
What’s included
The kit includes front coil springs, radius arms, I beam brackets, a pitman arm, extended length SS brake lines, a rear block and U-bolt kit and ES3000 front and rear shocks. Shock boots are not included.









