Overview
The Pro Comp Suspension 95-404FB is a 4 inch riser block with a non-tapered design. It is sold individually, so a set needs two blocks, one for each side.
Key features
- 4 inch rear lift
- Non-tapered design
- Sold individually
Non-tapered risers explained
A non-tapered riser keeps the same thickness from front to back, so it raises the axle without adjusting the angle of the pack. That makes the driveline angle change more noticeable than it would with a tapered block. Plan to measure the driveshaft and u-joint angles once the riser is in, and make a note of any vibration at highway speed.
Because the block is sold individually, both rear springs need an identical riser for an even lift. Match the blocks by height and shape before installing. Re-torque the U-bolts after the first few drives, and check that the axle has not shifted sideways as the pack settles.
- Use identical blocks on both springs
- Measure driveline angles after install
- Watch for vibration at highway speed
- Re-torque U-bolts after the first drives
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 95-404FB |
| UPC | 614901126945 |
| Lift height | 4 in |
| Position | Rear |
| Taper | Non-tapered |
| Sold as | Individually |
Vehicle fitment
Check your spring and axle setup before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Use this riser only on the rear. A riser block does not belong on the front of any vehicle.
What’s included
One non-tapered rear riser block.





