Overview
It is a set of two rear coil springs that give 4 inches of rear lift on the 2007–2014 and 2018 Jeep Wrangler (JK) in two-door and four-door models. It is available for the 70th Anniversary, Rubicon, Sahara, Sport, X and Unlimited Rubicon, Unlimited Sahara and Unlimited Sport trims.
The springs are made for the Pro Comp Stage II kit and form part of a larger suspension setup. Each spring is a preset coil with a specific spring rate, which provides the lift and improves ride characteristics.
A 4-inch rear lift changes the driveline angle and the rear geometry, so the angles should be measured after installation.
Key features
- 4 inches of rear lift
- Works for two-door and four-door JKs
- Set of 2 for the rear
- Made for the Pro Comp Stage II kit
- Preset coil with a specific spring rate
Stage II setup and driveline
A Stage II kit is built as a group, so the springs are one part of a larger setup. Shocks, control arms and brake lines may need to be matched to the new rear height. Before fitting, lay out the parts and confirm which ones are present for the job.
A 4-inch rear lift raises the axle and shifts the driveshaft angle, so the driveline needs to be checked after installation. Excess angle can cause vibration, and worn U-joints can make the problem worse. Look at the U-joints and the driveshaft slip yoke for wear, and retest after the first drive on the road.
Rear springs wear over time, and sagging springs lower the back end again. Inspect the coil ends and rubber isolators at regular service intervals, and replace any spring that shows cracks or sagging. Keep the rear shocks in good condition so they can handle the taller stance.
- Stage II kit parts before fitting
- Driveline angle after installation
- U-joints and slip yoke for wear
- Coil ends for cracks or sagging
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 55217 |
| UPC | 614901117882 |
| Position | Rear |
| Lift | 4 inches |
| Quantity | Set of 2 |
| Kit | Pro Comp Stage II kit |
| Fitment type | Direct fit |
Vehicle fitment
Pro Comp lists these rear coil springs as a direct fit for the 2007–2014 and 2018 Jeep Wrangler (JK), in two-door and four-door models, including the 70th Anniversary, Rubicon, Sahara, Sport, X and Unlimited trims named above.
The list does not include the 2015–2017 JK or the JL. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because these springs are for a Stage II setup, check the rest of that kit’s parts before fitting them. Measure the driveline angles and get an alignment once everything is in place.
What’s included
A set of 2 rear coil springs with a 4-inch lift.
Not included: the rest of the Pro Comp Stage II kit, which these springs are made for.









