Overview
The Pro Comp 95-100B is a 1 inch rear lift block, sold as a pair, that raises the rear of a vehicle by one inch. It is a flat aluminum riser block, and its non-tapered profile is meant to keep the vehicle’s driveshaft angle.
Each block has a center pin location with a 9/16 by 1.0 pin size. It is a rear block only, so it adds lift at the rear and does not change the front. Confirm the pin fit and mounting on your rear axle before ordering.
Key features
- 1 inch lift height
- Flat block style
- Aluminum riser block
- Non-tapered design
- Center pin location
Before you install
A rear lift block raises the axle relative to the frame, which changes the angle of the driveshaft and pinion. Steeper angles can wear the u-joints faster and cause vibration at highway speed. A flat block with a non-tapered profile helps keep the pinion angle closer to the transmission output on many setups, but the angles still need to be measured after the lift is in place.
Blocks also change the length and angle of the shocks, brake lines and sway bar links. Check that brake lines have enough slack and that the shocks still have full travel. Many owners find that a longer driveshaft or a fresh set of u-joints is needed when the lift goes higher. Re-torque the axle fasteners after the first drive and recheck the blocks at the first oil change.
- Measure the driveshaft angle before and after the lift
- Check brake line slack
- Re-torque axle nuts after the first drive
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 95-100B |
| UPC | 614901111552 |
| Position | Rear |
| Lift height | 1 inch |
| Block style | Flat |
| Block material | Aluminum |
| Block profile | Non-tapered |
| Pin size | 9/16 x 1.0 |
| Pin location | Center |
| Sold as | Pair |
Vehicle fitment
No vehicle is named for this block. It is a rear lift part, so fit depends on your rear axle and spring setup rather than on a model year.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
After installing the blocks, check the driveshaft angle. The non-tapered design helps keep that angle, but a lift changes the driveline geometry, so measure it.
What’s included
A pair of 1 inch rear lift blocks.




