Overview
The Power Trax 2310-LR is a right lock automatic locker for C-clip Dana 35 axles with 27 splines, for non-ABS applications. It fits front or rear axle locations. C-clip axles hold each shaft in place with a clip at the axle end rather than a bolted retainer.
The locker adds traction for demanding use, and the ring and pinion setup stays unchanged. A side gear hub check for 1993 models is covered in the installation notes.
Key features
- Automatic locker for non-ABS Dana 35 applications
- 27 spline axle design
- C-clip axle type
- Ring and pinion setup not altered
- Front or rear axle locations listed
Preparing a C-clip axle
A C-clip axle keeps each shaft retained with a clip at the axle end, so the clips and bearings are exposed once the cover comes off. Before a locker goes in, inspect the axle shafts, bearings and seals for wear. Old clips should be replaced rather than reused, since a clip that has been bent or fatigued may not hold the shaft securely under load.
Locking differentials put more stress on axle parts than an open carrier does. Hard turns on dry pavement can load the axle shafts and the locker in ways a stock differential does not, so check the shaft ends and clip grooves before installation and again after the first trail outings. Keep a spare set of clips in the toolbox when wheeling.
- Replace worn C-clips and seals during the job
- Inspect bearings and axle shaft ends
- Clean the housing and check the cover gasket surface
- Use a torque wrench on the cover bolts
Specifications
| Brand | Power Trax |
|---|---|
| Part number | 2310-LR |
| UPC | 698231805893 |
| Locker type | Automatic locker |
| Lock side | Right |
| Axle spline count | 27 splines |
| Axle type | Dana 35 |
| Axle retention | C-clip |
| ABS application | Non-ABS |
| Axle location | Front or rear |
| Popular axle manufacturer | Dana |
| Fitment field | Universal Fit |
Vehicle fitment
Before ordering, match the year, model and trim to your vehicle. This unit covers the Dana 35 axle type, non-ABS applications and 27 splines.
Dana 35 axles with ABS or a different spline count are not covered by these figures. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the factory side gear hub before installing. A hub of 1.625 means this locker is the right one, while a 1.56 hub calls for Power Trax application listing #PTX2311-LR instead. A qualified differential shop should handle the check and fit.
What’s included
The package is the Power Trax 2310-LR right lock automatic locker.
Not included: No hardware or C-clip parts are described.







