Overview
The Power Trax 2311-LR is a right-side automatic locking differential for a Dana 35 rear axle with 27 splines. It is a complete replacement differential case, so it swaps in for the stock case rather than being added as a kit. It is built for rugged use and suits owners who want more traction.
No vehicle models or years are named, so the Dana 35 axle type, rear location and 27-spline count are the points to match to your housing.
Key features
- Automatic locker on the right side of the axle
- Complete replacement differential case rather than an add-on installation
- The ring and pinion setup is not altered by this swap.
- Can be installed in the front, the rear or both positions
- Designed for demanding applications.
Replacing the whole case
A complete replacement differential case is a different job from adding a locker kit. The old case is removed and the new unit takes its place, so the carrier, bearings and pinion depth all need careful attention. Many owners choose this approach when the original case has worn gears or when they want a locker without reusing the old internals.
Before pulling the axle, mark the housing position and check the cover, gasket and axle shafts for wear. Ring and pinion condition matters, so a clean gear pattern check helps confirm proper mesh. Use gear oil suited to locking differentials, and fill to the correct level once the cover is back on.
- Inspect axle shaft seals
- Check the cover gasket before refilling
- Replace worn bearings while the housing is open
- Measure backlash during reassembly
Specifications
| Brand | Power Trax |
|---|---|
| Part number | 2311-LR |
| UPC | 698231805909 |
| Axle type | Dana 35 |
| Axle location | Rear |
| Axle spline | 27 splines |
| Differential type | Automatic locker |
| Locker side | Right |
| Configuration | C clip with ABS lock |
| Axle manufacturer | Dana |
Vehicle fitment
No vehicle is tied to this differential. It is a universal fit for the Dana 35 rear axle with 27 splines, so axle type and spline count determine whether it matches.
Check the axle housing against the Dana 35 rear location and 27-spline count before choosing this part. Make sure the fit lines up with your vehicle’s year, model and trim before ordering.
Installation notes
The ring and pinion setup is not altered by this swap. A differential is heavy, so have a qualified shop install it if you have not done axle work before.
What’s included
Hardware is not included in the set. Lay out the arriving parts against your install plan before fitting.







