Overview
The Power Trax 9203923125 is a Trac-Loc case no-slip traction unit for Chrysler 9.25 inch rear axles. Power Trax’s own copy is inconsistent on spline count: one line says 27-spline axles, another says 31 splines.
The unit reuses the existing carrier and needs no gear setup. It is for track lock differentials only, and it runs smoothly on the street.
Key features
- Reuses the existing carrier, per the manufacturer
- No gear setup needed
- Made for track lock differentials only
- Smooth street manners noted by Power Trax
- Rear location for Chrysler 9.25 inch axles
Checking your carrier and lock
A Trac-Loc case reuses the existing carrier, which keeps the job closer to a case swap than a full axle rebuild. Track lock differentials engage through a clutch pack that holds both axle shafts together, so the lock type must match the unit before installation. Check the lock design on your current carrier and the spline count on each axle shaft.
Because the spline count matters for the match, measure or count the splines on your axle before ordering. Inspect the carrier bearings and cover gasket while the old case is out, and clean the mating surfaces so the cover seals properly. A worn clutch pack or damaged ring gear should be replaced at the same time.
- Count splines on each axle shaft
- Confirm the lock type on the carrier
- Inspect the clutch pack for wear
- Clean the housing and cover surfaces
Specifications
| Brand | Power Trax |
|---|---|
| Part number | 9203923125 |
| UPC | 662960011702 |
| Axle type | Chrysler 9.25 inches |
| Axle location | Rear |
| Axle spline | 31 splines (27-spline axles also mentioned) |
| Differential type | Automatic locker |
| Lock type | Track lock (Trac-Loc) |
| Axle manufacturer | Chrysler |
Vehicle fitment
No vehicle is named. Power Trax lists universal fit for Chrysler 9.25 inch rear axles, but the spline count must be settled first.
Confirm the spline count and lock type of your axle before choosing this unit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Lifting gear and a shop with axle experience suit this heavy work, and the spline count should be confirmed before any parts are removed.
What’s included
Review the parts supplied against the job before you start.









