Overview
The Power Stop Performance Powder Coated Front Calipers with Brackets S2012 (part number PSTS2012) are a remanufactured front caliper pair for the 1995–2004 Toyota Tacoma.
These calipers are intended for enthusiasts and drop in where the stock calipers were. Power Stop says they look and perform well behind stock or custom wheels.
Power Stop remanufactures the caliper and bracket in its Chicago, IL facility and treats them to a high-temperature red powder-coat. The boots and seals are new premium parts, and the caliper pins are lubricated with high-temperature silicone.
Key features
- Front calipers with brackets, supplied as a pair
- Premium silicone lubrication for smoother operation
- Every caliper inspected for quality and safety
- Pressure tested to prevent leaks
- New bleeder screws, stainless steel hardware clips and brand new pins where applicable
- High-temperature EPDM rubber for extended life
Tacoma front brake upkeep
Front brakes on a compact pickup see steady use in town and heavier loads on the road. Caliper slide pins need periodic cleaning and light lubrication so the caliper floats evenly, and a pin that binds can wear one pad faster than the other. Rubber boots keep dirt and water out, so a split boot is a reason to service the caliper before it fails.
Because the hydraulic circuit is opened during a caliper change, fresh brake fluid and a proper bleed sequence matter. Keep the bleeder screws clean and use a sealed container when filling. Test the pedal before driving, and recheck the calipers for leaks after a short test drive.
- Clean slide pins whenever pads are changed
- Inspect boots for splits or swelling
- Recheck for leaks after the first drive
Specifications
| Brand | Power Stop |
|---|---|
| Part number | PSTS2012 |
| Product type | Remanufactured brake calipers |
| Position | Front |
| Finish | High-temperature red powder-coat |
| Fit | Direct fit |
| Quantity | Pair |
Vehicle fitment
It fits the 1995–2004 Toyota Tacoma in Base, DLX, SR5, Limited, Pre Runner and S-Runner versions.
A separate without-brackets version is made for the 1995–2003 Tacoma. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Bleed the brakes after installation, since the hydraulic circuit is opened when a caliper comes off.
What’s included
A pair of front calipers with brackets, plus new bleeder screws, stainless steel hardware clips and pins where applicable.
Not included: Brake pads, rotors and brake fluid for the Tacoma front axle.








