Overview
The Power Stop Performance Powder Coated Front Calipers with Brackets S2942 (part number PSTS2942) are a remanufactured front caliper pair for the 2014–2017 Ford Escape.
These calipers are intended for enthusiasts and drop in where the stock calipers were. Power Stop says they look and perform well behind stock or custom wheels.
Power Stop remanufactures the caliper and bracket in its Chicago, IL facility and treats them to a high-temperature red powder-coat. The boots and seals are new premium parts, and the caliper pins are lubricated with high-temperature silicone.
Key features
- Front calipers with brackets, supplied as a pair
- Premium silicone lubrication for smoother operation
- Each caliper inspected for quality and safety
- Pressure tested against leaks
- New bleeder screws, stainless steel hardware clips and pins included where applicable
- High-temperature EPDM rubber for longer life
Caliper seals and pins
The seals inside a caliper keep brake fluid in and dirt out, and the boots protect the piston from road spray and grit. When a boot tears or a seal weeps, moisture gets into the piston bore and the caliper can start to stick. Inspect the boots by hand at each pad change, looking for cracks, swelling or fluid tracks on the piston.
The caliper pins allow the caliper to slide as the pads wear. Pins that feel stiff, dry or corroded can cause one-sided wear and a pull under braking. Remove the old grease, clean the pin bores, and apply fresh high-temperature silicone lubricant before reassembly. Front pads usually wear faster than rear pads, so pin care is worth checking often.
Specifications
| Brand | Power Stop |
|---|---|
| Part number | PSTS2942 |
| Product type | Remanufactured brake calipers |
| Position | Front |
| Finish | High-temperature red powder-coat |
| Fit | Direct fit |
| Quantity | Pair |
Vehicle fitment
The S2942 fits the 2014–2017 Ford Escape in S, SE and Titanium versions.
Earlier and later Escape generations are not in the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Bleed the brakes after the calipers are fitted; replacing a caliper opens the hydraulic circuit.
What’s included
A pair of front calipers with brackets, plus new bleeder screws, stainless steel hardware clips and pins where applicable.
Not included: Brake pads, rotors and fresh brake fluid.










