Overview
The Poison Spyder Rear DeFender Flares in bare steel (part number 14-05-B70) are bolt-on flares for the rear of a vehicle, built from 3/16 inch steel plate. They are designed to match Poison Spyder’s front DeFenders, and they can be added to existing Crusher Corners or to other manufacturers’ full corner armor.
The flares are tubeless, with no thinner tube outer rail as found on traditional tube fenders. The outer edge is formed from 3/16 inch plate with a full underside return for strength, and they give 3 inches of tire coverage.
Key features
- Made from 3/16 inch plate steel
- Tubeless construction, with no tube outer rail
- Outer edge formed from 3/16 inch plate with a full underside return
- Bolt-on mounting plate cut with CNC laser
- Countersunk holes so the bolt heads sit flush
- 3 inch tire coverage
- Bare steel finish
Rear flare clearance and trimming
Rear flares cover the tire where the body meets the wheel well, so their job is to keep mud, rocks and spray off the sides of the vehicle. Coverage depends on how the flare sits over the tire at full suspension travel, which is why the amount of tire coverage matters as much as the steel thickness. Before fitting, look at the tire size you run and the clearance between the tire and the new edge when the suspension is compressed and extended.
Because cutting or drilling may be needed, measure twice and mark the body before making any cut. Sealing bare steel edges helps slow rust, and touching up paint at fastener holes is a good habit. After the first few drives, check that the bolts are still snug and that the flare has not contacted the tire on articulation.
- Check tire clearance at full articulation
- Mark and measure before any cutting
- Seal fresh cuts with paint or primer
- Re-check fasteners after the first drives
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 14-05-B70 |
| UPC | 614901725483 |
| Position | Rear |
| Material | 3/16 inch steel plate |
| Tire coverage | 3 inches |
| Finish | Bare steel |
| Installation type | Cutting or drilling required |
Vehicle fitment
They are direct-fit DeFender Flares for Poison Spyder’s own corner armor and for full corner armor from other makers. Confirm fit for your vehicle’s year, model and trim, and confirm your armor is compatible, before ordering.
Confirm your vehicle’s year, model and trim before ordering, and confirm the armor you have is compatible.
Installation notes
Cutting or drilling is required, so plan for that before fitting the flares. The mounting plate has countersunk holes so the bolt heads sit flush with the surface.
What’s included
The product is the rear flare set. No mounting hardware is described.














