Overview
The Poison Spyder BFH II Rear Bumper with D-Ring Tabs, part number 17-17-021-D, is a low profile faceted rear bumper for the JK Wrangler in bare 3/16″ plate steel. Poison Spyder says BFH stands for “Built For the Hammers”, and the bumper is aimed at hardcore four-wheelers.
The bumper is no wider than the Jeep JK Wrangler’s rear body tub. Its angled facets help it slide over rocks while protecting the corner of the tub, and it has no provisions for a spare tire carrier. It may be compatible with the OE tailgate-mounted spare tire carrier depending on the size of the spare tire used. It has CNC machined high clearance recovery shackle tabs cut from 1-inch thick plate steel, made for 3/4-inch recovery shackles.
Installation is not bolt-on: it requires cutting and trimming the Jeep’s rear frame rails, stock bumper mounts and rear crossmember.
Key features
- CNC laser cut 3/16″ plate steel, bare
- Low profile faceted design for trail obstacles
- No wider than the JK rear body tub
- High clearance recovery shackle tabs from 1″ thick plate steel
- No spare tire carrier provisions
- Laser-cut steel template included for the frame cuts
- Fits 2-door and 4-door models
Before you start the cuts
A bumper that replaces the factory rear structure changes how the vehicle carries load, so treat the frame work as a structural job rather than a cosmetic one. Mark the cut lines with the template before making any cut, and check that the rails and crossmember are square to each other afterward. Small errors at the rear often show up later as a misaligned tailgate or uneven bumper gaps.
Bare steel rusts quickly if left unprimed, so paint or powder coat the bumper and any cut edges before the vehicle sees wet trails. Recovery shackle tabs should be checked for bolt torque after each run, because they take heavy shock loads. Keep the shackles rated for your recovery use and inspect them for wear as well.
- Dry-fit the bumper before any frame cuts
- Prime cut edges and bare steel right away
- Inspect shackle tabs for cracks after heavy recovery
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 17-17-021-D |
| UPC | 614901751161 |
| Part type | Rear bumper |
| Material | 3/16″ plate steel |
| Finish | Bare steel |
| Shackle tabs | CNC machined, 1″ thick plate steel, for 3/4″ shackles |
| Spare tire carrier | No provisions |
| Hitch receiver | None; companion crossmember 17-17-030 is a separate part |
| Installation | Requires cutting frame rails and rear crossmember |
Vehicle fitment
This bumper is for the Jeep JK Wrangler, covering the 2007 to 2018 Jeep Wrangler (JK) in 2-door and 4-door form.
Other Wrangler generations are not covered, and the companion crossmember 17-17-030 is a different part. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting the stock rear frame rails and crossmember, so read Poison Spyder’s installation instructions first. A laser-cut steel template helps with the cuts.
The stock crossmember may be plated across the cut or removed completely; the plating materials are not included. This version is designed for the non-receiver crossmember, not the one with the integrated hitch receiver, part number 17-17-030.
The bumper is bare steel and needs painting or powder coating before final installation.
What’s included
- Rear bumper
- Recovery shackle tabs
- Laser-cut steel template
Not included: recovery shackles, and the materials for plating the crossmember.









