Overview
The Oracle Lighting 2012-003 is a red pre-wired on/off flush mount LED switch rated for 12 volts, designed to mount through a 16MM hole in a panel. The red power ring lights when the switch is engaged, so the on state reads clearly in low light.
It is a practical choice for adding an illuminated accessory control inside a vehicle. The pre-wired terminal avoids separate leads, and the nickel-plated push button has a defined click. Since no vehicle years, makes or models are named, it is treated as universal fit.
Key features
- Red illuminated power ring that lights when activated
- Pre-wired terminal
- Designed to sit flush in a 16MM hole
- Heavy-duty brass assembly
- Nickel-plated finish with a noticeable click; CE compliant
Panel prep and bench testing
A clean opening is what lets a flush switch sit level and hold its position. Cut the hole carefully, remove burrs from the edges, and check that the housing slides in without forcing it. Test the switch on the bench before it goes into the panel, so you know the ring lights and the button clicks before the trim is back in place. That check is much easier than pulling a finished panel apart later.
Plan for clearance behind the panel as well. The terminal and wire need room, and the wire should not rub against sharp edges or moving parts. Use a fuse in the 12-volt feed and label the control wire so future changes are simple. An illuminated switch is often added alongside other accessory controls, so keeping each circuit identifiable helps with troubleshooting.
- Deburr the cutout before fitting the housing
- Bench test the ring and click first
- Keep the terminal clear of moving trim
Specifications
| Brand | Oracle Lighting |
|---|---|
| Part number | 2012-003 |
| UPC | 201200320145 |
| Illumination color | Red |
| Switch type | Push button, on/off |
| Operating voltage | 12 volts |
| Mounting hole | 16MM |
| Assembly | Heavy-duty brass |
| Finish | Durable nickel plate |
| Waterproof | No |
| Certification | CE compliant |
Vehicle fitment
It is universal fit, so no particular year, make, model or trim is matched to it. Suitability depends on the 16MM panel opening and the 12-volt wiring. Check fit for your vehicle’s year, model and trim before you order it.
No specific vehicles are named, so there are no close models to exclude. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Use a fuse in the 12-volt feed and wire the pre-wired terminal to the circuit you are controlling. Test the switch on the bench before pressing the flush housing into the panel.
What’s included
One pre-wired red on/off flush mount LED switch. No other hardware is named for this product.
Not included: The 16MM mounting hole, which must be prepared in the panel.









