Overview
The Oracle Lighting plug and play reverse lights wiring adapter, part number ORC5880-504, is made for the 2020–2026 Jeep Gladiator JT. It sits between the factory tail light plug and the factory tail light, which simplifies connecting Oracle rear bumper LED reverse lights.
It is designed for the 2020–2026 Jeep Gladiator JT and serves as the connection point between the factory tail light plug and the factory tail light for reverse lighting.
Key features
- Plug and play design between the factory tail light plug and tail light
- Supplied locking connectors for the reverse light connection
- Built for Oracle rear bumper LED reverse lights
- Listed by Oracle for direct fit on the 2020–2026 Jeep Gladiator JT
Rear lighting checks
Reverse lights draw power from the rear lighting circuit, so the first step is confirming that the factory tail light plug is in good condition. Look for melted housings, green corrosion on the pins, or pins pushed out of position before connecting the adapter. A clean, fully seated connection makes the reverse function easier to test and less likely to fail after rough roads.
Route added wires away from moving parts, exhaust heat and sharp edges, and secure them with clips rather than loose ties. Use fused wiring for the added lights, then check each lamp for reverse function before closing the trim. Rules for rear lighting vary by area, so review local requirements before driving with modified lamps.
- Inspect the factory tail light plug for corrosion
- Route new wiring away from heat and moving parts
- Test reverse function before finishing the install
Specifications
| Brand | Oracle Lighting |
|---|---|
| Part number | ORC5880-504 |
| Type | Plug and play reverse lights wiring adapter |
| Connectors | Locking connectors (supplied) |
Vehicle fitment
The manufacturer fitment list covers the 2020–2026 Jeep Gladiator, including the 80th Anniversary, Altitude, High Altitude, Launch Edition, Mojave, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport trims.
Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Connect the adapter between the factory tail light plug and the tail light, then attach the Oracle reverse lights with the supplied locking connectors. Because this work touches rear lighting circuits, use fused wiring for the added lights and check local road-use rules for rear lighting.
What’s included
The adapter and the supplied locking connectors.
Not included: The Oracle rear bumper LED reverse lights the adapter is designed to connect.









